★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 350-001 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/350-001-dumps.html


Want to know Actualtests 350-001 Exam practice test features? Want to lear more about Cisco CCIE Cisco Certified Internetworking Expert certification experience? Study Realistic Cisco 350-001 answers to Most up-to-date 350-001 questions at Actualtests. Gat a success with an absolute guarantee to pass Cisco 350-001 (CCIE Cisco Certified Internetworking Expert) test on your first attempt.

2021 Jan 350 001 braindump:

Q281. Your network is suffering from regular outages. After troubleshooting, you learn that the transmit lead of a fiber uplink was damaged. Which two features can prevent the same issues in the future? (Choose two.)

A. root guard

B. loop guard

C. BPDU guard

D. UDLD

E. BPDU skew detection

Answer: BD


Q282. How many bytes make up the spanning-tree bridge ID? 

A. 4 

B. 8 

C. 12 

D. 16 

Answer: B


Q283. Which two IPv6 address pairs can be assigned on a point-to-point link with a /125 mask? (Choose two.)

A. 2001:DB8::1 and 2001:DB8::2

B. 2001:DB8::9 and 2001:DB8::10

C. 2001:DB8::10 and 2001:DB8::17

D. 2001:DB8::1 and 2001:DB8::18

Answer: AC


Q284. Which statement is correct in reference to IPv6 multicast?

A. IPv6 multicast uses Multicast Listener Discovery.

B. The first 8 bits of an IPv6 multicast address are always FF (1111 1111).

C. IPv6 multicast requires MSDP.

D. PIM dense mode is not part of IPv6 multicast.

Answer: A


Q285. Refer to the exhibit. As a network administrator, you have configured a dual-rate, dual-bucket policer in accordance with RFC 2698 on the serial interface of you router, connecting to your provider. The SLA with your provider states that you should only send AF31 (limited to 150 kb/s), AF32 (limited to 50 kb/s)and AF33 (best effort). Your service provider claims you are not conforming to the SLA. Which two things are wrong with this configuration? (Choose two.)

A. The configuration of a service policy on half-duplex Ethernet interfaces is not supported.

B. The class class-default sub-command of the policy-map limit command should be set to the DSCP default.

C. The violate action is wrong.

D. This policer configuration is not implementing RFC 2698 dual-bucket, dual-rate.

E. The policer is configured in the wrong class.

Answer: CE


Updated lead2pass 350-001:

Q286. An expanding company is deploying leased lines between its main site and two remote sites. The bandwidth of the leased lines is 128kb/s each, terminated on different serial interfaces on the main router. These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs, and has therefore reserved sufficient bandwidth in a low latency queue on each interface for the VOIP traffic. Users now complain about bad voice quality although no drops are observed in the low latency queue. What action will likely fix this problem?

A. mark VOIP traffic with IP precedence 6 and configure only fair-queue' on the links

B. configure the scheduler allocate 3000 1000 command to allow the OoS code to have enough CPU cycles

C. enable class-based traffic shaping on the VOIP traffic class

D. enable Layer 2 fragmentation and interleaving on the links

E. enable Frame Relay on the links and send voice and data on different Frame Relay PVCs

Answer: D


Q287. Refer to the exhibit.

We have IPv6 multicast configured between R5 and R6. Which two statements are true based on the partial command output shown? (Choose two.)

A. R6 has joined the multicast group, and it expires in 46 seconds

B. The rendezvous point address is FE80::21 6:47FF:FEBB:FFO.

C. The multicast group address is FF04::1 0.

D. The multicast entry is operating in dense mode.

E. The multicast route has been pruned.

Answer: CE


Q288. Which command is used to enable SSM with the range 232.0.0.0/8? 

A. ip pim ssm default 

B. ip pim ssm 232.0.0.0 255.0.0.0 

C. ip pim ssm range 50 access-list 50 permit 232.0.0.0 15.255.255.255 

D. ip pim enable default 

Answer: A


Q289. If shaping is configured with 128 KB/s and a committed burst of 3200 B/s, what would be the value of TC? 

A. 25 sec 

B. 25 ms 

C. 125 sec 

D. 125 ms 

Answer: B


Q290. Which two orders in the BGP Best Path Selection process are correct? (Choose two.)

A. Higher local preference, then lowest MED, then eBGP over iBGP paths

B. Higher local preference, then highest weight, then lowest router ID

C. Highest weight, then higher local preference, then shortest AS path

D. Lowest origin type, then higher local preference, then lowest router ID

E. Highest weight, then higher local preference, then highest MED

Answer: AC