★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 350-001 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/350-001-dumps.html


100% Correct of 350-001 free practice questions materials and interactive bootcamp for Cisco certification for candidates, Real Success Guaranteed with Updated 350-001 pdf dumps vce Materials. 100% PASS CCIE Cisco Certified Internetworking Expert exam Today!

2021 Jun 350 001 braindump:

Q31. As a network administrator, can you tell me what the root guard feature provides in a bridgednetwork?

A. It ensures that BPDUs sent by the root bridge are forwarded in a timely manner

B. It enforces the root bridge placement in the network

C. It ensures that all ports receiving BPDUs from the root bridge are in the forwarding state.

D. It ensures that the bridge is elected as root bridge in the network.

Answer: B


Q32. What does a unicast prefix-based IPv6 multicast address start with?

A. FF80

B. FF3

C. FF

D. FF7

Answer: B


Q33. Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message (knowing that the MSDP router is also configured as an RP for the PIM domain)?

A. Source-Active Message

B. PIM Join

C. PIM Hello

D. MSDP Register

Answer: A


Q34. Which standard supports multiple instances of spanning tree?

A. 802.1 D

B. 802.1s

C. 802.1w

D. 802.1 z

Answer: B


Q35. Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2. What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails, without using any type of EtherChannel link-bundling?


A. Increase the root bridge priority (increasing the numerical priority number) for VLAN 2 on Catalyst D so that port D2 becomes the root port on Catalyst D for VLAN 2.

B. Decrease the port priority on R2 for VLAN 2 on Catalyst R so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.

C. Decrease the path cost on R2 on Catalyst R for VLAN 2 so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.

D. Increase the root bridge priority (decreasing the numerical priority number) for VLAN 2 on Catalyst R so that R2 becomes the root port on Catalyst D for VLAN 2.

Answer: B


350-001 download

Most up-to-date cisco 350 001:

Q36. Refer to the exhibit. Based on the configuration shown, which queuing mechanism has been configured on interface serial.1/0?


A. PQ

B. CQ

C. WFQ

D. LLQ

E. CBWFQ

Answer: E


Q37. Refer to the exhibit.


Which two statements are correct? (Choose two.)

A. The packet is received on the private interface.

B. Zone-Based Firewall is configured on the router.

C. Logging is enabled for the access list.

D. Private is an identification of that ACE.

E. The Telnet connection is successfully set up.

Answer: CD


Q38. Refer to the exhibit.


A new Ethernet link was added to an existing OSPF network. It is possible to ping the remote end of the link, but the OSPF adjacency does not form. Which two commands configured on the interface could resolve the issue? (Choose two.)

A. ip ospf mtu-ignore

B. ip ospf flood-reduction

C. ip mtu 1500

D. ip mss 1500

Answer: AC


Q39. In which two spanning-tree port states is the port learning MAC addresses? (Choose two.) 

A. disabled 

B. blocking 

C. listening 

D. learning 

E. forwarding 

Answer: DE


Q40. Which value is used in the PIM TYPE field to indicate a register-stop message? 

A. 0 

B. 1 

C. 2 

D. 3 

Answer: C