★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 350-001 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/350-001-dumps.html


High quality of 350-001 free practice test materials and testing engine for Cisco certification for candidates, Real Success Guaranteed with Updated 350-001 pdf dumps vce Materials. 100% PASS CCIE Cisco Certified Internetworking Expert exam Today!

2021 Oct 350-001 pdf:

Q331. Refer to the exhibit. Voice traffic is marked "precedence 5." How much bandwidth is allocated for voice traffic during periods of congestion?

A. a minimum of 48 kb/s

B. a maximum of 48 kb/s

C. a minimum of 48% of the available bandwidth

D. a maximum of 48% of the available bandwidth

Answer: B


Q332. Refer to the exhibit.

You have just configured R5 and R6 to run EIGRPv6 as shown; the IPv6 ping from R5 to R6- loopback 0 is failing. Which statement could be the reason?

A. The loopback interfaces on R5 and R6 must be configured on an EIGRPv6 As number other than 56.

B. The loopback interfaces on R5 and R6 must be configured to EIGRPv6 As number 56.

C. You need to configure the EIGRPv6 router process on both routers.

D. You need to configure the EIGRPv6 router process in at least one of the routers

E. You should remove the ipv6 eigrp 56 from the loopback interfaces on both routers.

Answer: C


Q333. Which of the following is true about the MPLS header and its EXP field size?

A. The MPLS header is 2 bytes, and the EXP field is 3 bits long.

B. The MPLS header is 1 byte, and the EXP field is 3 bits long.

C. The MPLS header is 4 bytes, and the EXP field is 3 bits long.

D. The MPLS header is 3 bytes, and the EXP field is 3 bits long.

Answer: C


Q334. BGP-IPv6-0SPF-QOS-Case and Simlet

Refer to the exhibit.

Which statements are true aboutthe following policy map?

A. Packets between 200 and 1000 bytes will be marked with prec 2.

B. Packets less that 488 will be marked with ip prec 2.

C. Packets more that 500 will be marked with ip prec 2.

D. Packets with size that 200 will be marked with ip prec 2.

Answer: D


Q335. In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicast traffic to a group?

A. The source must send a PIM Register message to the rendezvous point (RP).

B. The source must first join the multicast group using IGMP before sending.

C. The source must perform a Request to Send (RTS) and Clear to Send (CTS) handshake with the PIM designated router (DR).

D. No control plane signaling needs to be performed; the source can simply begin sending on the local subnet.

Answer: D


Rebirth 350-001 torrent:

Q336. From which IPv6 address are EIGRPv6 hello messages sourced? 

A. Global unicast 

B. Link local 

C. Site local 

D. Unique local 

E. FF02::A 

Answer: B


Q337. Refer to the exhibit.

The next hops are learned via OSPF and IS-IS. Which path is selected as the best path for 10.168.0.1?

A. path 1, because it is an MPLS labeled path

B. path 1, because the next hop is learned via OSPF with an AD of 110, compared to 115 for IS-IS

C. path 2, because it has the highest router ID

D. path 2, because it has the lowest IGP metric

Answer: D


Q338. For the following ports, which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge?

A. root port

B. backup port

C. designated port

D. alternate port

Answer: A


Q339. Which two statements are true about RED? (Choose two.)

A. RED randomly drops packets before the queue becomes full.

B. RED is always useful, without dependency on flow.

C. RED increases the drop rate as the average queue size increases.

D. RED has a per-flow intelligence.

Answer: AC


Q340. Refer to the exhibit.

You are investigating connectivity issues on your LAN and have noticed that sometimes you cannot use Telnet from RTA to RTB. Sometimes, Telnet sessions will disconnect on RTA with the message "connection reset by peer." However, you can ping from RTA to RTB at all times. What is most likely the cause of this issue?

A. Quality of service is configured on RTA, limiting the Telnet sessions.

B. Quality of service is configured on RTB, limiting the Telnet sessions.

C. Control Plane Policing is configured on RTB, limiting the Telnet sessions.

D. On router RTB, the "login block" mode went to a "quiet period" for the IP address of RTA.

E. Another device that is connected to the switch is using the same IP address as RTB.

F. Another device that is connected to the switch is using the same MAC address as RTB.

Answer: E