★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 350-001 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/350-001-dumps.html
Proper study guides for Update Cisco CCIE Cisco Certified Internetworking Expert certified begins with Cisco 350-001 preparation products which designed to deliver the Highest Quality 350-001 questions by making you pass the 350-001 test at your first time. Try the free 350-001 demo right now.
2021 Jun testking ccie written 350-001:
Q101. Which configuration would make an IP SLA probe use a precedence value of 5?
A. ip sla 1
icmp-echo 1.1.1.1
tos 160
B. ip sla 1
icmp-echo 1.1.1.1
tos 20
C. ip sla 1
icmp-echo 1.1.1.1
precedence 5
D. ip sla 1
icmp-echo 1.1.1.1
dscp 20
Answer: A
Q102. On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between R1 and R2 fails, what is the maximum number of queries R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?
A. R3 will receive up to four queries for 192.168.1.0/24, one each from R2, R4, R5, and R6.
B. R3 will receive up eight queries for 192.168.1.0/24, one from R2, two from R4, three from R5, and four from R6.
C. R3 will receive one query for 192.168.1.0/24, since the remote routers, R4, R5, and R6, are natural stubs in EIGRP.
D. R3 will not receive any queries from R2, because there are no alternate paths for 192.168.1.0/24.
Answer: A
Q103. Which of the following is true about WRED?
A. WRED cannot be applied to the same interface as CQ, PQ, and WRED.
B. WRED drops packets from all flows.
C. WRED cannot mark with a probability denominator.
D. WRED cannot be applied to the voice queue.
Answer: D
Q104. The network administrator wants to enable an EtherChannel between two switches in "on" mode. The administrator connects the cables and enables the interfaces, but while configuring the EtherChannel in the first switch, a spanning-tree loop was detected. Which two of these procedures can avoid this problem? (Choose two.)
A. Configure the EtherChannel as "desirable" first.
B. Assign all interfaces to the same VLAN.
C. Disable PortFast on the interfaces in the EtherChannels.
D. Disable all interfaces first.
E. Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F. Fix cabling problems.
Answer: AD
Q105. Which two attributes need to match for two switches to become members of the same MST region? (Choose two.)
A. the table of 4096 elements that map the respective VLAN to STP instance number
B. VTP version
C. configuration revision number
D. native VLAN ID
Answer: AC
Most up-to-date ccie written exam code:
Q106. What are the "bound IP addresses" used for in LDP?
A. For each such address and mask /32, one label binding is created.
B. As the TCP endpoint, IP addresses are used by the LDP session.
C. These addresses are used to find the label binding to put in the LFIB, by looking up these IP addresses in the routing table.
D. These addresses are used for penultimate hop popping (PHP) when forwarding packets to the next router directly.
Answer: C
Q107. Which statement best describes OSPF external LSAs (type 5)?
A. OSPF external LSAs are automatically flooded into all OSPF areas, unlike type 7 LSAs, which require that redistribution be configured.
B. External LSAs (type 5) are automatically changed to type 1 LSAs at ASBRs.
C. Type 5 LSAs are route summaries describing routes to networks outside the OSPF Autonomous System.
D. External network LSAs (type 5) redistributed from other routing protocols into OSPF are not permitted to flood into a stub area.
Answer: D
Q108. Customer X has a hub-and-spoke Frame Relay network, with a central office and two branch offices (RemoteA and RemoteB). Each location has only one physical link to the Frame Relay cloud and RemoteB has a router that is not a Cisco router. Since the installation, there is no connectivity between RemoteB and the central office. What is a possible solution to this issue?
A. Because Frame Relay IETF encapsulation is only configurable at interface level, you must use IETF encapsulation on all routers.
B. This is not a possible scenario. A dedicated Frame Relay link to RemoteB is mandatory at the central office.
C. The router at RemoteB must be replaced by a Cisco router.
D. Use Frame Relay IETF encapsulation on a per-VC basis on the central office router.
E. There is a problem in the Frame Relay cloud, because Cisco routers are compatible with IETF Frame Relay.
Answer: D
Q109. Which one of these statements is true of OSPF type 5 LSAs?
A. They are used to summarize area routes to other areas.
B. They are used in not-so-stubby areas to propagate external routes.
C. They are used to notify areas of the ASBR.
D. They are flooded to all areas except stub areas (external route).
Answer: D
Q110. Which statement is true about loop guard?
A. Loop guard only operates on interfaces that are considered point-to-point by the spanning tree.
B. Loop guard only operates on root ports.
C. Loop guard only operates on designated ports.
D. Loop guard only operates on edge ports.
Answer: A