★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 350-001 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/350-001-dumps.html
You will have quick access for you to our Cisco 350-001 exam products after confirming the payment at Ucertify. The Cisco 350-001 practice questions with verified answers are usually compiled and revised by the subject matter specialists. Our own experts possess make excellent contributions to the Cisco Cisco exam products. We have many customers who have obtained the Cisco 350-001 certification. We are usually proud of the higher passing ratio since many of us start.
2021 Sep cisco 350 001:
Q191. While deploying a new switch, you accidentally connect ports 3/12 and 3/18 together, creating a loop. STP detected it and placed port 3/18 in blocking mode. Why did STP not place port 3/12 in blocking mode instead?
A. Port 3/12 was already up and forwarding before the loop was created.
B. Port priority is based on lowest priority and lowest port number.
C. You connected the wire on port 3/18 last.
D. None of the above, it is purely random.
Answer: B
Q192. While you are troubleshooting network performance issues, you notice that a switch is periodically flooding all unicast traffic. Further investigation reveals that periodically the switch is also having spikes in CPU utilization, causing the MAC address table to be flushed and relearned. What is the most likely cause of this issue?
A. a routing protocol that is flooding updates
B. a flapping port that is generating BPDUs with the TCN bit set
C. STP is not running on the switch
D. a user that is downloading the output of the show-tech command
E. a corrupted switch CAM table
Answer: B
Q193. Refer to the exhibit. You are asked to enable redirection for a network optimization engine that will be connected directly to your company CPE. What is the correct configuration to enable redirection for traffic optimization?
A. (config)#interface s0/0
(config-if)#ip wccp 61 out
(config)#interface e0/0
(config-if)#ip wccp 62 out
B. (config)#intetface s0/0
(config-if)#ip wccp 62 in
(config)#interface e0/0
(config-if)#ip wccp 61 in
C. (config)#interface s0/0
(config-if)#ip wccp 61 in
(config-if)#ip wccp 62 out
D. (config)#interface e0/0
(config-if)#ip wccp 61 in
(config-if)#ip wccp 62 out
Answer: D
Q194. Refer to the exhibit.
Which statement is correct?
A. This configuration is not valid.
B. Control Plane Policing is configured; however you cannot determine on which interface it is configured.
C. NTP is not configured on the router.
D. Telnet traffic will be dropped.
Answer: C
Q195. Refer to the exhibit.
Why is the interface in the up/down state?
A. There is no physical layer connection.
B. A span session has been configured with g5/2 as the destination.
C. There were too many input drops on the interface.
D. A span session has been configured with g5/2 as the source
Answer: B
Most up-to-date pass4sure ccie r&s 350-001:
Q196. Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider?
A. OSPF standard hellos
B. Cisco Discovery Protocol link detection
C. Bidirectional Forwarding Detection
D. Fast Link Pulse
E. autonegotiation
Answer: C
Q197. Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switchl. However, EtherChannel is not coming up. Which one of these statements could be a possible reason?
A. EtherChannel is only available in Cisco equipment.
B. The customer side is supposed to be running PAgP, which is a Cisco standard.
C. PAgP is not an IEEE standard. VRRP should be used.
D. The configuration on switch1 needs to be modified to use LACP.
Answer: D
Q198. Refer to the exhibit.
Which statement is correct about this configuration?
A. This is not a legal configuration.
B. The RD is a type 0 RD.
C. The RD is a type 1 RD.
D. The RD is a type 2 RD.
E. This is a special RD that is used only for management VRFs.
Answer: C
Q199. Drag & Drop
Answer:
Q200. Where should frame-relay traffic shaping be applied?
A. on the physical interface
B. on the subinterface
C. under the frame-relay map class
D. on any of the above
Answer: A