★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 200-125 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/200-125-dumps.html
200-125 is the perfect qualification audit to take up so that you can have a very successful vocation throughout Cisco. Theres lots of on line course that could provide help to prepare perfectly with the 200-125 audit. One would be able to get the whole list of questions. A fantastic 200-125 train audit would probably go over virtually all method of concerns asked during the 200-125 audit and this also gives an effective emulator from the genuine 200-125 check.
2021 Aug 200-125 exam answers
Q111. - (Topic 9)
Which command can you enter to view the ports that are assigned to VLAN 20?
A. Switch#show vlan id 20
B. Switch#show ip interface brief
C. Switch#show interface vlan 20
D. Switch#show ip interface vlan 20
Answer: A
Q112. - (Topic 3)
What are three features of the IPv6 protocol?
(Choose three.)
A. optional IPsec
B. autoconfiguration
C. no broadcasts
D. complicated header
E. plug-and-play
F. checksums
Answer: B,C,E
Topic 4, IP Routing Technologies
126. - (Topic 4)
Two routers named Atlanta and Brevard are connected via their serial interfaces as illustrated, but they are unable to communicate. The Atlanta router is known to have the correct configuration.
Given the partial configurations, identify the fault on the Brevard router that is causing the lack of connectivity.
A. incompatible IP address
B. insufficient bandwidth
C. incorrect subnet mask
D. incompatible encapsulation
E. link reliability too low
F. IPCP closed
Answer: D
Q113. - (Topic 9)
What is the purpose of the POST operation on a router?
A. determine whether additional hardware has been added
B. locate an IOS image for booting
C. enable a TFTP server
D. set the configuration register
Answer: A
Q114. - (Topic 6)
A network administrator needs to configure port security on a switch. Which two statements are true? (Choose two.)
A. The network administrator can apply port security to dynamic access ports.
B. The network administrator can apply port security to EtherChannels.
C. When dynamic MAC address learning is enabled on an interface, the switch can learn new addresses, up to the maximum defined.
D. The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
E. The network administrator can configure static secure or sticky secure MAC addresses in the voice VLAN.
Answer: C,D
Q115. - (Topic 2)
A switch is configured with all ports assigned to VLAN 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?
A. More collision domains will be created.
B. IP address utilization will be more efficient.
C. More bandwidth will be required than was needed previously.
D. An additional broadcast domain will be created.
Answer: D
Far out 200-125 question:
Q116. - (Topic 9)
Which protocol advertises a virtual IP address to facilitate transparent failover of a Cisco routing device?
A. FHRP
B. DHCP
C. RSMLT
D. ESRP
Answer: A
Q117. - (Topic 4)
Which command reveals the last method used to powercycle a router?
A. show reload
B. show boot
C. show running-config
D. show version
Answer: D
Q118. - (Topic 1)
Refer to the exhibit.
After HostA pings HostB, which entry will be in the ARP cache of HostA to support this transmission?
A. Exhibit A
B. Exhibit B
C. Exhibit C
D. Exhibit D
E. Exhibit E
F. Exhibit F
Answer: A
Q119. - (Topic 3)
The network administrator needs to address seven LANs. RIP version 1 is the only routing protocol in use on the network and subnet 0 is not being used. What is the maximum number of usable IP addresses that can be supported on each LAN if the organization is using one class C address block?
A. 8
B. 6
C. 30
D. 32
E. 14
F. 16
Answer: C
Q120. - (Topic 2)
Which two of these statements regarding RSTP are correct? (Choose two.)
A. RSTP cannot operate with PVST+.
B. RSTP defines new port roles.
C. RSTP defines no new port states.
D. RSTP is a proprietary implementation of IEEE 802.1D STP.
E. RSTP is compatible with the original IEEE 802.1D STP.
Answer: B,E