★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 642-997 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/642-997-dumps.html


You will get the particular comprehensive reason once you encounter issues during your 642-997 examine. Actualtests give you the particular 642-997 Implementing Cisco Data Center Unified Fabric (DCUFI) v5.0 key points legibly in the 642-997 places. These are greatly saving your expenses to take part in the particular Cisco classes.

2021 Jun cisco press 642-997:

Q31. Which item represents the process that allows FCoE multihop using T11 standard FC-BB-5? 

A. distributed FCF 

B. FIP proxy 

C. N Port proxy 

D. FIP snooping 

Answer: D 


Q32. Which option is a restriction of the unified ports on the Cisco UCS 6200 Series Fabric Interconnect when connecting to the unified fabric network? 

A. Direct FC connections are not supported to Cisco MDS switches 

B. The FCoE or Fibre Channel port allocations must be contiguous on the 6200. 

C. 10-G Fibre Channel ports only use SFP+ interfaces. 

D. vPC is not supported on the Ethernet ports. 

Answer: B 


Q33. Which two statements about SAN zoning on Cisco Nexus switches are true? (Choose two.) 

A. Zoning is enforced by examining the destination ID field. 

B. Devices can only belong to one zone. 

C. Only one zone set can be activated at any time. 

D. A zone can only be a member one zone set. 

E. Zoning must be administered from the primary SAN switch in the fabric. 

F. Zone configuration changes are nondisruptive. 

Answer: CF 


Q34. Refer to the exhibit. 


This multilayer Cisco Nexus switch had been the active virtual gateway for Group 1 before it became temporarily unavailable. What will happen to GLBP Group 1 when this device becomes available again? 

A. The currently active router remains active. 

B. It depends on the priority value that is configured active on the router. 

C. The Cisco Nexus switch becomes the active virtual gateway after 600 seconds. 

D. It depends on the weighting values that are configured active on the router. 

Answer: A 


Q35. Which two statements about implementing Cisco NPV and NPIV on a Cisco Nexus 5000 Series switch are true? (Choose two.) 

A. STP must run inside the FP network. 

B. All VLANs must be in the same mode, CE, or FP. 

C. FP port can join the private and nonprivate VLANs. 

D. Only F and M series modules can run FabricPath. 

E. These require an enhanced Layer 2 license to run. 

Answer: BE 


642-997 test engine

Leading 642-997 dcufi study guide:

Q36.  




What is the status of FCoE license on Cisco Nexus 5548 switch? 

A. FCoE license is not installed 

B. FCoE license is installed, but it is expired 

C. FCoE license is installed and status is enabled 

D. FCoE license does not need to be installed because it is part of ENTERPRISE_PKG 

Answer: A 


Q37. Which three selections represent implementations of Cisco VN-Link technology? (Choose three.) 

A. Cisco Nexus 1000V 

B. Cisco Nexus 2000 FEX 

C. Cisco VM-FEX 

D. VMware PTS 

E. vMotion 

Answer: ACD 


Q38. Which Cisco Nexus feature is best managed with DCNM-SAN? 

A. VSS 

B. domain parameters 

C. virtual switches 

D. AAA 

Answer: B 


Q39. What must be enabled on the interface of a multicast-enabled device to support the Source Specific Multicast feature? 

A. IGMP version 3 

B. IGMP version 2 

C. IGMP version 1 

D. PIM 

Answer: A 


Q40. Refer to the command below. When configuring an SVS connection on the Cisco Nexus 5000 Series Switch, which device is being referenced as the remote IP address? 

nexus5500-2(config-svs-conn)# remote ip address 10.10.1.15 port 80 vrf management 

A. ESX or ESXi host 

B. vCenter 

C. vPC peer switch 

D. Cisco IMC management 

Answer: B