★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 642-813 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/642-813-dumps.html
100% Correct of 642-813 exams materials and bible for Cisco certification for consumer, Real Success Guaranteed with Updated 642-813 pdf dumps vce Materials. 100% PASS implementing cisco switched networks exam Today!
2021 Sep ccnp switch 642-813 lab manual pdf:
Q21. When configuring private VLANs, which configuration task must you do first?
A. Configure the private VLAN port parameters.
B. Configure and map the secondary VLAN to the primary VLAN.
C. Disable IGMP snooping.
D. Set the VTP mode to transparent.
Answer: D
Q22. DRAG DROP
Place the associated redundancy options and features on the left into the correct topics (network, system, and management levels).
Answer:
Q23. Refer to the exhibit.
What information can be derived from the output?
A. Interfaces FastEthernet3/1 and FastEthernet3/2 are connected to devices that are sending BPDUs with a superior root bridge parameter and no traffic is forwarded across the ports. After the sending of BPDUs has stopped, the interfaces must be shut down administratively, and brought back up, to resume normal operation.
B. Devices connected to interfaces FastEthernet3/1 and FastEthernet3/2 are sending BPDUs with a superior root bridge parameter, but traffic is still forwarded across the ports.
C. Devices connected to interfaces FastEthernet3/1 and FastEthernet3/2 are sending BPDUs with a superior root bridge parameter and no traffic is forwarded across the ports. After the inaccurate BPDUs have been stopped, the interfaces automatically recover and resume normal operation.
D. Interfaces FastEthernet3/1 and FastEthernet3/2 are candidates for becoming the STP root port, but neither can realize that role until BPDUs with a superior root bridge parameter are no longer received on at least one of the interfaces.
Answer: C
Q24. What does the command udld reset accomplish?
A. allows a UDLD port to automatically reset when it has been shut down
B. resets all UDLD enabled ports that have been shut down
C. removes all UDLD configurations from interfaces that were globally enabled
D. removes all UDLD configurations from interfaces that were enabled per-port
Answer: B
Q25. Which two characteristics apply to Cisco Catalyst 6500 Series Switch supervisor redundancy using NSF? (Choose two.)
A. supported by RIPv2, OSPF, IS-IS, and EIGRP
B. uses the FIB table
C. supports IPv4 and IPv6 multicast
D. prevents route flapping
E. independent of SSO
F. NSF combined with SSO enables supervisor engine load balancing
Answer: BD
Renewal ccnp switching 642-813 pdf:
Q26. DRAG DROP
You have been tasked with planning a VLAN rolution that with connect a server in one building to several hosts in another building. The solution should be built using the local VLAN model and Layer 3 switching at distribution layer. Drat the questions that you would ask the network administrator before you start the planning from the left to the right. Not all questions will be used.
Answer:
Q27. Refer to the exhibit, which is from a Cisco Catalyst 3560 Series Switch.
Which statement about the Layer 3 routing functionality of the interface is true?
A. The interface is configured correctly for Layer 3 routing capabilities.
B. The interface needs an additional configuration entry to enable IP routing protocols.
C. Since the interface is connected to a host device, the spanning-tree portfast command must be added to the interface.
D. An SVI interface is needed to enable IP routing for network 192.20.135.0.
Answer: A
Q28. What action should a network administrator take to enable VTP pruning on an entire management domain?
A. Enable VTP pruning on any client switch in the domain.
B. Enable VTP pruning on every switch in the domain.
C. Enable VTP pruning on any switch in the management domain.
D. Enable VTP pruning on a VTP server in the management domain.
Answer: D
Q29. DRAG DROP
Place the associated traffic types on the left into the correct order, based on priority (highest to lowest priority COS value)
Answer:
Q30. What is the effect of applying the switchport trunk encapsulation dot1q command to a port on a Cisco Catalyst switch?
A. By default, native VLAN packets going out this port are tagged.
B. Without an encapsulation command, 802.1Q is the default encapsulation if DTP fails to negotiate a trunking protocol.
C. The interface supports the reception of tagged and untagged traffic.
D. If the device connected to this port is not 802.1Q-enabled, it is unable to handle 802.1Q packets.
Answer: C