★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-365 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/300-365-dumps.html


Cause all that matters here is passing the Cisco 300-365 exam. Cause all that you need is a high score of 300-365 Deploying Cisco Wireless Enterprise Networks exam. The only one thing you need to do is downloading Exambible 300-365 exam study guides now. We will not let you down with our money-back guarantee.

Q1. A customer has implemented several WLANs in an auditorium utilizing a newly dedicated WLC and is experiencing excessive channel utilization regardless of occupancy. Which action reduces channel utilization without removing SSIDs? 

A. Disable MCS data rates 0 through 11. 

B. Disable MCS data rates used by 40 MHz channels. 

C. Disable data rates that use CCK. 

D. Disable VHT data rates. 

Answer: C 


Q2. Scenario 

There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are. 

What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.) 

A. Change the AP in the Employees-East-Wing AP Group. 

B. Change the IP Address in the east-wing interface. 

C. Change the VLAN Identifier in the east-wing interface. 

D. Enable Dynamic AP Management in the east-wing interface. 

E. Change the Port Number to 2 in the east-wing interface. 

F. Add the Primary Controller and IP address to the 3700-East-Wing AP. 

G. Change the SSID in the Employees-East-Wing AP Group. 

H. Change the Interface/Interface Group In the Employees-East-Wing AP Group. 

Answer: D,F,G,H 


Q3. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three) 

A. verify that Global Multicast mode has been enabled 

B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients. 

C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth 

D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows 

E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet 

F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN 

Answer: A,B,E 


Q4. A customer has "quiet" wireless clients that use static IP addresses. Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.) 

A. Disable DHCP address assignment required. 

B. Enable passive client. 

C. Disable allow AAA override. 

D. Enable static IP tunneling. 

E. Disable DHCP server override. 

Answer: A,E 


Q5. A network engineer must ensure that corporate wireless users have a better experience than guest wireless users. Which two configurations fulfil requirement? (Choose two.) 

A. Override per-SSID bandwidth contracts on the corporate WLAN to reserve bandwidth. 

B. Modify the corporate WLAN to the Platinum QoS policy. 

C. Enable 802.1ptag on the Gold QoS pofccyto honor prioritized traffic. 

D. Adjust the guest WLAN radio policy to 80211 b/g only. 

E. Change the guest WLAN to the Bronze QoS policy. 

Answer: B,E 


Q6. A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured. How many image transfers between the WLC and APs will occur? 

A. 7 

B. 1 

C. 5 

D. 2 

Answer: D 


Q7. A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.) 

A. When only WMM is enabled, information element number 1 QBSS Load information element is sent out in the beacons and probe responses. 

B. When only WMM is enabled, information element number 3 QBSS Load information element is sent out in the beacons and probe responses. 

C. When the client CAC limit is supported, information element number 2 is sent out in the beacons and probe responses on the bg radios. 

D. When the client CAC limit is supported, information element number 1 is sent out in the beacons and probe responses on the bg radios. 

E. When only WMM is enabled, information element number 2 QBSS Load information element is sent out in the beacons and probe responses. 

Answer: D,E 


Q8. When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.) 

A. Upstream marked as Best Effort. 

B. Upstream marked as ToS CS4. 

C. Upstream marked as DSCP EF. 

D. Downstream marked as DSCP EF. 

E. Downstream marked as Best Effort. 

F. Downstream marked as Silver. 

Answer: C,E 


Q9. A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented. How should the engineer perform the password recovery? 

A. Use a console cable. 

B. Contact Cisco TAC and arrange an RMA of the MSE. 

C. Boot the MSE using the software installation DVD. 

D. The Password can be reset using Prime Infrastructure. 

Answer: A 


Q10. RAG DROP 

Drag the QoS values from the left and drop them in the correct descending order of priority on the right. 

Answer: