★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-365 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/300-365-dumps.html
2021 Apr 300-365 exam engine
Q21. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group?
A. 224.0.0.13
B. 224.0.1.39
C. 224.0.0.14
D. 224.0.140
Answer: D
Q22. A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to correct the issue?
A. controller IGMP snooping
B. unicast AP Multicast Mode
C. broadcast forwarding
D. multicast AP Multicast Mode
Answer: B
Q23. A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. What three items should the administrator check next to troubleshoot the issue? (Choose three)
A. IGMP snooping is turned off because the client cannot request to join a group, only access points can.
B. Video-stream for the multicast video is configured in the controller.
C. WLAN has been set for a QoS value of Platinum.
D. WLAN has been configured to allow multicast-direct to work correctly and multicast-direct has been enabled globally.
E. WLAN has been set for a QoS value of Gold.
F. RTSP is used to stream the video due to wireless multicast not using acknowledgements.
Answer: B,D,E
Q24. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead?
A. 10 Seconds
B. 60 Seconds
C. 15 Seconds
D. 30 Seconds
Answer: D
Q25. A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.)
A. All ports participate in the LAG by default when LAG is enabled on the controller, y
B. Dynamic interfaces and management are moved to port 1
C. Primary and secondary ports are needed for each interface.
D. Multiple untagged interfaces to the same port are not allowed.
E. EtherChannel must be configured for mode "on" on the switch.
F. Only one functional physical port is needed to continue to pass traffic.
G. Multiple LAGs are permitted on the controller.
H. The WLC does not need to be rebooted to enable the LAG configuration.
Answer: A,D,E,F
Q26. A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue?
A. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller.
B. Under the SSID, make sure that 802.1 Iris configured and running for the clients.
C. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly.
D. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group.
Answer: D
Q27. You are deploying a combination of Cisco Unified Wireless IP Phones 7921G and 7925G at your branch offices in a centralized call processing environment that requires high availability at branch locations. Which three components need to be verified before the wireless IP phones can be deployed? (Choose three.)
A. Sufficient SRST license support at each branch location
B. Support for local voice mail
C. Branch gateways support MoH
D. Properly configured QoS over the IP WAN links
E. Support for single number reach
F. Support for E.164 dialing
G. Sufficient IP phone licenses in the Cisco Unified Communications Manager cluster
Answer: A,D,G
Q28. A customer has limited staff to manage a wireless network. The customer wants a solution that requires minimum hardware. Which type of architecture do you propose?
A. centralized
B. distributed
C. cloud-based
D. unified
Answer: A
Q29. Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)
A. |f Ethernet and wireless are available, it attempts to discover only via Ethernet.
B. if Ethernet is disconnected, it attempts to connect wirelessly using AWPP.
C. if only wireless is available and it is configured as a MAP, it does not attempt to connect to a WLC.
D. If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless.
E. |f Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option.
Answer: A,B
Q30. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking?
A. Uses existing LWAPP-enabled Cisco Unified Networking components.
B. Proprietary client hardware or software is required.
C. Better accuracy and precision.
D. Reduced calibration effort.
Answer: B