What Practical 201 Free Practice Questions Is

NEW QUESTION 1
Which IP address will the client address be changed to when SNAT automap is specified within a Virtual Server configuration?

• A. The floating self-IP address on the VLAN where the packet leaves the system.
• B. The floating self-IP address on the VLAN where the packet arrives on the system.
• C. It will alternate between the floating and non floating self-IP address on the VLAN where the packet leaves the system so that port exhaustion is avoided.
• D. It will alternate between the floating and non floating self-IP address on the VLAN where the packet arrives on the system so that port exhaustion is avoided.

Answer: A

NEW QUESTION 2
A BIG-IP Administrator is receiving intermittent reports from users that SSL connections to the BIG-IP device are failing. Upon checking the log files, the BIG-IP Administrator notices the following error message:
ere tmm<instance>[<pid>]: 01260008:3: SSL transaction (TPS) rate limit reached
After reviewing statistics, the BIG-IP Administrator notices there are a maximum of 1200 client-side SSL TPS and a maximum of 800 server-side SSL TPS.
What is the minimum SSL license limit capacity the BIG-IP Administrator should upgrade to handle this peak?

• A. 2000
• B. 400
• C. 800
• D. 1200

Answer: D

NEW QUESTION 3
How should a BIG-IP Administrator control the amount of traffic that a newly enabled pool member receives.

• A. set the Slow Ramp Time
• B. set a Connection Limit
• C. set the Priority Group Activation
• D. set a Health Monitor

Answer: A

Explanation:
Slow Ramp Time
Specifies the duration during which the system sends less traffic to a newly-enabled pool member. The amount of traffic is based on the ratio of how long the pool member has been available compared to the slow ramp time, in seconds. Once the pool member has been online for a time greater than the slow ramp time, the pool member receives a full proportion of the incoming traffic. Slow ramp time is particularly useful for the least connections load balancing mode.
Setting this to a nonzero value can cause unexpected Priority Group behavior, such as load balancing to a low-priority member even with enough high-priority servers.

NEW QUESTION 4
Assuming that systems are synchronized, which action could take place if the fail over cable is connected correctly and working properly, but the systems cannot communicate over the network due to external network problems?

• A. If network failover is enabled, the standby system will assume the active mode.
• B. Whether or not network failover is enabled, the standby system will stay in standby mode.
• C. Whether or not network failover is enabled, the standby system will assume the active mode.
• D. If network failover is enabled, the standby system will go into active mode but only until the network recovers.

Answer: B

NEW QUESTION 5
Which process or system can be monitored by the BIG-IP system and used as a failover trigger in a redundant pair configuration?

• A. bandwidth utilization
• B. duplicate IP address
• C. CPU utilization percentage
• D. VLAN communication ability

Answer: D

NEW QUESTION 6
The incoming client IP address is 205.12.45.52. The last five connections have been sent to members C, D, A, B, B. Given the virtual server and pool definitions and the statistics shown in the graphic, which member will be used for the next connection?

• A. 10.10.20.1:80
• B. 10.10.20.2:80
• C. 10.10.20.3:80
• D. 10.10.20.4:80
• E. 10.10.20.5:80

Answer: A

NEW QUESTION 7
A BIG-IP Administrator is creating a new Trunk on the BIG-IP device. What objects should be added to the new Trunk being created?

• A. Interfaces
• B. Network routes
• C. VLANS
• D. IP addresses

Answer: A

Explanation:
trunk is a portchannel, you need to add a physical interface.

NEW QUESTION 8
A standard virtual server has been associated with a pool with multiple members. Assuming all other settings are left at their defaults, which statement is always true concerning traffic processed by the virtual server?

• A. The client IP address is unchanged between the client side connection and the serverside connection.
• B. The server IP address is unchanged between the client side connection and the serverside connection.
• C. The TCP ports used in the client side connection are the same as the TCP ports serverside connection.
• D. The IP addresses used in the clientside connection are the same as the IP addresses used in the serverside connection.

Answer: A

NEW QUESTION 9
Given that VLAN failsafe is enabled on the external VLAN and the network that the active BIG-IP's external VLAN is connected to has failed, which statement is always true about the results?

• A. The active system will note the failure in the HA table.
• B. The active system will reboot and the standby system will go into active mode.
• C. The active system will failover and the standby system will go into active mode.
• D. The active system will restart the traffic management module to eliminate the possibility that BIG-IP is the cause for the network failure.

Answer: A

NEW QUESTION 10
Which statement is true about the synchronization process, as performed by the Configuration Utility or by typing b config sync all?

• A. The process should always be run from the standby system.
• B. The process should always be run from the system with the latest configuration.
• C. The two /config/bigip.conf configuration files are synchronized (made identical) each time the process is run.
• D. Multiple files, including /config/bigip.conf and /config/bigip_base.conf, are synchronized (made identical) each time the process is run.

Answer: C

NEW QUESTION 11
For a given Virtual Server, the BIG-IP must perform SSL Offload and negotiate secure communication overTLSvl.2only.
What should the BIG-IP Administrator do to meet this requirement?

• A. Configure a custom SSL Profile (Client) and select no TLSvl in the options list
• B. Configure a custom SSL Profile (Client) with a custom TLSV1.2 cipher string
• C. Configure a custom SSL Profile (Server) and select no TLSvl in the options list
• D. Configure a custom SSL Profile (Server) with a custom TLSV1.2 cipher string

Answer: B

Explanation:
no TLSvl only disables TLS1.0, TLS1.1 is still used and does not meet the requirements.

NEW QUESTION 12
Refer to the exhibit.
During a planned upgrade lo a BIG-IP HA pair running Active/Standby, an outage to application traffic is reported shortly after the Active unit is forced to Standby Reverting the flower resolves the outage. What should the BIG-IP Administrator modify to avoid an outage during the next for over event?

• A. The Tag voice on the Standby device
• B. The interface on the Active device to 1.1
• C. The Tag value on the Active device
• D. The Interface on the Standby device to 1.1

Answer: A

NEW QUESTION 13
Refer to the exhibit


The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.
Which action should the BIG-IP Administrators to resolve this issue?

• A. Set Port Lockdown of Set IP to Allow All
• B. Change Auto Last Hop to enabled
• C. Assign a physical interface to the new VLAN
• D. Create a Floating Set IP Address

Answer: C

NEW QUESTION 14
A BIG-IP Administrator is setting up a new BIG-IP device. The network administrator reports that the interface has an incompatible media speed. The BIG-IP Administrator needs to change this setting
manually.
From which location should the BIG-IP Administrator perform this task?

• A. On the Front Console
• B. In the TMOS Shell Command line
• C. In the Configuration Utility, Network > Interface
• D. In the Configuration Utility, System > Configuration

Answer: C

NEW QUESTION 15
What should the 816-IP Administrator provide when opening a new ticket with F5 Support?

• A. bigip.license file
• B. QKViewfile
• C. Device root password
• D. SSL private keys

Answer: B

NEW QUESTION 16
A BIG-IP Administrator is configuring a pool with members who have differing capabilities. Connections to pool members must be load balanced appropriately.
Which load balancing method should the BIG-IP Administrator use?

• A. Least Sessions
• B. Least Connections (member)
• C. Fastest (node)
• D. Weighted Least Connections (member)

Answer: D

NEW QUESTION 17
Which log file should the BIG-IP Administrator check to determine if a specific user tried to log in to the 8IG-IP Configuration by utility?

• A. /var/log/pam/tally/log
• B. /ver/log/secure
• C. /var/log/trn
• D. /var/log/http.d

Answer: B

NEW QUESTION 18
Refer to the exhibit.

A BIG-IP Administrator needs to deploy an application on the BIG-IP system to perform SSL offload and re-encrypt the traffic to pool members.
During testing, users are unable to connect to the application. What must the BIG-IP Administrator do to resolve the issue?

• A. Remove the configured SSL Profile (Client)
• B. Configure Protocol Profile (Server) as splitsession-default-tcp
• C. Enable Forward Proxy in the SSL Profile (Client)
• D. Configure an SSL Profile (Server)

Answer: D

Explanation:
According to the requirements of the subject, the client and server must be configured with ssl profile.

NEW QUESTION 19
......