★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-355 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/200-355-dumps.html


Want to know Ucertify 200-355 Exam practice test features? Want to lear more about Cisco Implementing Cisco Wireless Network Fundamentals certification experience? Study Guaranteed Cisco 200-355 answers to Far out 200-355 questions at Ucertify. Gat a success with an absolute guarantee to pass Cisco 200-355 (Implementing Cisco Wireless Network Fundamentals) test on your first attempt.

2021 Apr 200-355 exam guide

Q11. An engineer wants to setup WPA2 Enterprise using EAP-TLS and a remote RADIUS server. What device(s) would the engineer specify the EAP type on? 

A. the supplicant and authentication server 

B. the supplicant and authenticator 

C. the authenticator and authentication server 

D. the supplicant only 

E. the authentication server only 

Answer:


Q12. Which change can correct inband access to the WLC? 

A. change the switch FastEthernetO/1 duplex setting 

B. change the switch FastEthernetO/1 speed setting 

C. enable the switch FastEthernetO/1 spanning-tree port-fast trunk 

D. change the switch FastEthernetO/1 trunk encapsulation 

E. change the WLC management interface to use DHCP 

F. change the WLC management interface VLAN 

G. change the WLC configuration of NTP 

H. browse to WLC via http://10.10.10.10 

Answer:


Q13. An 802.11g network is experiencing intermittent signal degradation and Spectrum Analyzer is being used to try and locate the problem. What two interferers would likely be identified? (Choose two.) 

A. multiple cell phones 

B. microwave oven 

C. FM Radio 

D. cordless phone 

E. document scanner 

Answer: B,D 


Q14. Which device divides a signal between two antennas? 

A. splitter 

B. lightening arrestor 

C. attenuator 

D. amplifier 

Answer:


Q15. Which two actions would you use to begin to troubleshoot an access point that fails to join a wireless LAN controller successfully? (Choose two.) 

A. SSH to the AP. 

B. SSH to the Cisco WCS. 

C. SSH to the Cisco WLC. 

D. Issue the Cisco WLC command debug capwap events enable 

E. Issue the Cisco WLC command show capwap events 

Answer: C,D 


Abreast of the times 200-355 exam question:

Q16. An engineer wants to have users who connect to a WLAN be redirected to a terms-of-service page with the company logo and a login. What should be configured on the WLAN to enable this capability? 

A. Layer 2 IEEE 802.1x 

B. Web Policy Slash Page Web Redirect 

C. Web Policy Authentication 

D. AAA Servers 

E. Web Policy Passthrough 

Answer:


Q17. Refer to the exhibit. 

Which GUI item do you click to configure maps with APs in Cisco WCS? 

A. Configure 

B. Client 

C. CleanAir 

D. Services 

E. Administration 

F. Monitor 

Answer:


Q18. What is an interferer that an engineer may see in Cisco CleanAir? 

A. microwave ovens 

B. rogue APs 

C. malicious clients 

D. co-channel interference 

Answer:


Q19. Which two statements about AES-CCMP are true? (Choose two.) 

A. It is an encryption algorithm used in the 802.11i security protocol. 

B. It is defined in 802.1X. 

C. It is the encryption algorithm used in TKIP implementations. 

D. It is required in WPA. 

E. It is required in WPA2. 

Answer: A,E 


Q20. Which description best describes upfade in a multipath environment? 

A. In this situation, multiple signal paths are not sent at exactly the same time. The receiver receives a positive crest on the primary signal and a negative crest on the secondary signal. 

B. In this situation, the multiple signal paths are distorted and difficult to understand. 

C. In this situation, the multiple signal paths are weaker than they should be because the signals are out of phase with each other. 

D. In this situation, the signal is stronger than it should be because multiple signal paths are received twice at exactly the same time, which results in the multiple signals being in-phase. 

Answer: