★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 200-355 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/200-355-dumps.html
It is impossible to pass Cisco 200-355 exam without any help in the short term. Come to Examcollection soon and find the most advanced, correct and guaranteed Cisco 200-355 practice questions. You will get a surprising result by our Refresh Implementing Cisco Wireless Network Fundamentals practice guides.
2021 Mar 200-355 training
Q161. A customer cannot access the GUI on the Cisco 5508 Wireless Controller from the management interface due to network failure. Which interface can the customer use to access the WLC GUI until the network issues are resolved?
A. virtual
B. dynamic
C. console port
D. service port
Answer: D
Q162. A controller is connected to a Cisco Catalyst switch. The switch port configuration looks like this:
interface GigabitEthernet 1/0/10
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,20,30,50
switchport trunk native vlan 20
switchport mode trunk
Which controller CLI command assigns its management interface to the native VLAN interface of the Cisco Catalyst switch?
A. config interface vlan management 0
B. config interface vlan management 1
C. config interface vlan management 20
D. config interface vlan management 30
E. config interface vlan management 50
Answer: A
Q163. Refer to the exhibit. A customer is using central web authentication with a Cisco 5508 Wireless Controller and Cisco Identity Services Engine. An error occurs when wireless clients are redirected to the hosted splash page. What is causing the client error?
A. Secure Web Mode is disabled on the WLC.
B. OCSP is disabled on the WLC.
C. Management Via Dynamic Interface is disabled on the WLC.
D. Ethernet Multicast Forwarding is enabled on the WLC.
Answer: A
Q164. A help desk ticket states that a wireless access point has not joined its controller and is flashing rapidly. How can the help desk administer the access point with the default settings?
A. console
B. SSH
C. Telnet
D. HTTP
E. HTTPS
Answer: A
Q165. An enterprise needs their iPhones to connect to the EAP-TLS network. How should the devices be configured?
A. push profile and certificate through Configuration Utility
B. configure directly through Settings application
C. email certificate to device then configure through Settings application
D. download certificate from web page then configure through Settings application
E. push profile and certificate through iTunes
Answer: A
Up to the immediate present 200-355 exam cost:
Q166. An engineer recently removed a WLC from a WCS, but the APs associated to the WLC are still showing on the WCS. What is a reason for this?
A. The associated APs must be removed manually.
B. The APs must be removed from the WCS map.
C. The hold-down timer must expire before the APs will be removed.
D. The APs must be audited.
Answer: A
Q167. The introduction of consumer phones and tablets into enterprise WLANs can have an impact on 802.11a/b/g/n deployments. The Apple iPhone 4 and iPad 2 are very common examples.
Which statement best describes the abilities of these devices?
A. The Apple iPhone 4 and the iPad 2 use 2.4 GHz and 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams.
B. The Apple iPhone 4 uses only 2.4 GHz and the iPad 2 only uses 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams.
C. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 only uses one spatial stream and the iPad 2 uses two spatial streams.
D. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 and the iPad 2 use only one spatial stream.
Answer: D
Q168. After installing a Cisco 5508 Wireless Controller using the default settings, how often will the RRM update occur?
A. 30 seconds
B. 60 seconds
C. 300 seconds
D. 600 seconds
E. 3600 seconds
F. 7200 seconds
Answer: D
Q169. The network administrator receives complaints of slow wireless network performance and performs a sniffer trace of the wireless network in preparation for migration to 802.11n. The sample capture shows frames that contains AP beacons with NonERP_Present bit set to 1 and frames with RTS/CTS.
Which two conclusions can be interpreted from these frames? (Choose two.)
A. The network is performing slowly because 802.11n clients are already mixed with 802.11g clients.
B. The network is performing slowly because 802.11b clients still exist in the network.
C. The network is performing slowly because a wireless client is incorrectly configured, which results in RF interference.
D. Possible 802.11b wireless clients are located only in the AP cell radius where the sniffer capture was performed.
E. Possible 802.11b wireless clients could be located anywhere in the wireless network.
Answer: B,E
Q170. RAG DROP
Answer: