★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 200-355 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/200-355-dumps.html
Tested of 200-355 actual test materials and braindumps for Cisco certification for customers, Real Success Guaranteed with Updated 200-355 pdf dumps vce Materials. 100% PASS Implementing Cisco Wireless Network Fundamentals exam Today!
2021 Sep ccda vs ccna wireless 200-355:
Q71. An engineer recently removed a WLC from a WCS, but the APs associated to the WLC are still showing on the WCS. What is a reason for this?
A. The associated APs must be removed manually.
B. The APs must be removed from the WCS map.
C. The hold-down timer must expire before the APs will be removed.
D. The APs must be audited.
Answer: A
Q72. Refer to the exhibit.
Which GUI item do you click to configure maps with APs in Cisco WCS?
A. Configure
B. Client
C. CleanAir
D. Services
E. Administration
F. Monitor
Answer: F
Q73. Which protocol helps the administrator to determine whether a detected rogue AP is in the network of the organization?
A. RLDP
B. RCP
C. RDP
D. RAPP
Answer: A
Q74. An installation uses a 21dBi parabolic dish. It is connected to the 802.11n radio via low loss antenna coax rated at 4dB loss/100 feet. After testing, it has been determined that 2mW of power will be lost in the cable. An EIRP producing 200mW is desired. What should the transmit power be set to?
A. 8mW
B. 3dBm
C. 3.16mW
D. 5mW
Answer: C
Q75. An engineer has been noticing the power settings on several of the office APs change from day to day ever since two more APs were installed. After logging into the WLC, the engineer verifies that the power levels on 4 of the 802.11n radios are fluctuating up and down. What is the reason for this?
A. The controller has the APs in H-REAP mode and are on a Layer 2 connection instead of Layer 3.
B. The RRM has revealed a bad survey and is attempting to power down some of the radios to make up for it.
C. The WLC has created temporary coverage holes while stepping through power levels for some of the APs.
D. Several APs have high levels of overlapping coverage in the same area and the WLC is using RRM to correct the cell sizes AP coverage.
Answer: D
Renewal fh 200-355:
Q76. Refer to the exhibit. A customer is using central web authentication with a Cisco 5508 Wireless Controller and Cisco Identity Services Engine. An error occurs when wireless clients are redirected to the hosted splash page. What is causing the client error?
A. Secure Web Mode is disabled on the WLC.
B. OCSP is disabled on the WLC.
C. Management Via Dynamic Interface is disabled on the WLC.
D. Ethernet Multicast Forwarding is enabled on the WLC.
Answer: A
Q77. An engineer needs an AP with at least two spatial streams, four receivers, and three transmitters. Which device meets these requirements?
A. 2x4:3
B. 2x3:4
C. 4x3:2
D. 3x4:2
Answer: D
Q78. An AP was reset while working on the correct association to a Cisco WCS version 7.0.
Which item was cleared during the reset?
A. static IP address
B. the location ID of the AP
C. WLC primary, secondary, tertiary
D. AP name
E. certificate
F. Nothing was cleared.
Answer: F
Q79. An engineer would like to setup secure authentication for a wireless network that will utilize single sign-on. Which two authentication methods can be used to accomplish this? (Choose two.)
A. LDAP
B. RADIUS
C. Local authentication
D. WEP
E. PSK
Answer: A,B
Q80. Which governing body analyzes the applications and environments in which wireless networks are used?
A. EIRP
B. ETSI
C. FCC
D. IEEE
E. WiFi Alliance
Answer: D