★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-120 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/200-120-dumps.html


Act now and download your Cisco 200-120 test today! Do not waste time for the worthless Cisco 200-120 tutorials. Download Refresh Cisco CCNA Cisco Certified Network Associate CCNA (803) exam with real questions and answers and begin to learn Cisco 200-120 with a classic professional.

2021 Nov ccna 200-120 free practice test:

Q61. - (Topic 4) 

On a corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs? 

A. a router with subinterfaces configured on the physical interface that is connected to the switch 

B. a router with an IP address on the physical interface connected to the switch 

C. a switch with an access link that is configured between the switches 

D. a switch with a trunk link that is configured between the switches 

Answer: A 


Q62. - (Topic 9) 

Which protocol is the Cisco proprietary implementation of FHRP? 

A. HSRP 

B. VRRP 

C. GLBP 

D. CARP 

Answer: A 


Q63. - (Topic 3) 

Refer to the exhibit. 

What is the most appropriate summarization for these routes? 

A. 10.0.0.0 /21 

B. 10.0.0.0 /22 

C. 10.0.0.0 /23 

D. 10.0.0.0 /24 

Answer: B 


Q64. - (Topic 2) 

Which switch would STP choose to become the root bridge in the selection process? 

A. 32768: 11-22-33-44-55-66 

B. 32768: 22-33-44-55-66-77 

C. 32769: 11-22-33-44-55-65 

D. 32769: 22-33-44-55-66-78 

Answer: A 


Q65. - (Topic 7) 

In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN? 

A. during high traffic periods 

B. after broken links are re-established 

C. when upper-layer protocols require high reliability 

D. in an improperly implemented redundant topology 

E. when a dual ring topology is in use 

Answer: D 


Avant-garde ccna dumps for 200-120:

Q66. - (Topic 9) 

Which two features can dynamically assign IPv6 addresses? (Choose two.) 

A. IPv6 stateless autoconfiguration 

B. DHCP 

C. NHRP 

D. IPv6 stateful autoconfiguration 

E. ISATAP tunneling 

Answer: A,B 


Q67. - (Topic 1) 

Refer to the exhibit. 

Based on the information given, which switch will be elected root bridge and why? 

A. Switch A, because it has the lowest MAC address 

B. Switch A, because it is the most centrally located switch 

C. Switch B, because it has the highest MAC address 

D. Switch C, because it is the most centrally located switch 

E. Switch C, because it has the lowest priority 

F. Switch D, because it has the highest priority 

Answer: E 


Q68. - (Topic 9) 

After you configure the Loopback0 interface, which command can you enter to verify the status of the interface and determine whether fast switching is enabled? 

A. Router#show ip interface loopback 0 

B. Router#show run 

C. Router#show interface loopback 0 

D. Router#show ip interface brief 

Answer: A 


Q69. - (Topic 1) 

Which of the following statements describe the network shown in the graphic? (Choose two.) 

A. There are two broadcast domains in the network. 

B. There are four broadcast domains in the network. 

C. There are six broadcast domains in the network. 

D. There are four collision domains in the network. 

E. There are five collision domains in the network. 

F. There are seven collision domains in the network. 

Answer: A,F 


Q70. - (Topic 4) 

Which command reveals the last method used to powercycle a router? 

A. show reload 

B. show boot 

C. show running-config 

D. show version 

Answer: D