Up To Date Data Center Professional (JNCIP-DC) JN0-682 Test Preparation

NEW QUESTION 1
You are considering deploying a MAC-VRF type routing instance with a VLAN-bundle service type. In this scenario, which two statements are correct? (Choose two.)

• A. It can be implemented in a bridge overlay architecture.
• B. VLAN normalization is supported.
• C. Multiple VLAN IDs per EVI are supported.
• D. It can be implemented in an ERB architecture.

Answer: AC

NEW QUESTION 2
You are asked to enable visibility into your EVPN-VXLAN network traffic by monitoring traffic continuously. Which two statements are correct in this scenario? (Choose two.)

• A. You cannot enable sFlow monitoring on each interface individually.
• B. The sFlow agent is installed by default on your OFX Series switch.
• C. You must enable sFlow monitoring on each interface individually.
• D. The sFlow agent needs to be manually installed on your QFX Series switch.

Answer: BC

NEW QUESTION 3
Exhibit.

Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down. Referring to the exhibit, which statement is correct?

• A. Type-1 routes for each VM will expire one at a time.
• B. Type-1 routes for all VMs in the site will expire all at once.
• C. Type-1 routes for all VMs in the site will be withdrawn all at once.
• D. Type-1 routes for each VM will be withdrawn one at a time.

Answer: C

NEW QUESTION 4
You are asked to configure JTI on the QFX Series devices in your data center fabric. You must use sensors with the least amount of latency. Which type of sensor should you use in this scenario?

• A. Python sensors
• B. JTI native sensors
• C. analog sensors
• D. JTI OpenConfig sensors

Answer: B

NEW QUESTION 5
You manage a data center with a 5-stage EVPN-VXLAN IP fabric. You notice that there are suboptimal paths used between the leaf and spine as well as the spine and super spine. What is one way to solve this issue?

• A. Configure the super spine and spine layers to all use the same ASN.
• B. Configure the spine layer for EBGP and the leaf layer for IBGP
• C. Configure the spine layer so that all spines in a POD share the same ASN.
• D. Configure the leaf layer so that all leaf devices share the same ASN.

Answer: B

NEW QUESTION 6
You are asked to deploy an Ethernet bridging design in a data center with the criteria shown below.
-- Routing must occur on the spine devices.
- VTEPs must terminate on the leaf devices.
- Facilitate inter-VLAN communication.
-- Layer 2 gateways must be present on spine and leaf devices. Which architecture should you use in this scenario?

• A. edge-routed bridging architecture
• B. centrally-routed bridging architecture
• C. bridge overlay architecture
• D. collapsed spine architecture

Answer: B

NEW QUESTION 7
Exhibit.

Referring to the exhibit, you have a data center with two PODs. Seamless EVPN-VXLAN stitching is used to facilitate communication between the PODs.
Which three statements are true in this scenario? (Choose three.)

• A. AVXLAN tunnel can form between L2 and S1.
• B. A VXLAN tunnel can form between S1 and S2.
• C. AVXLAN tunnel can form between L1 and L2.
• D. AVXLAN tunnel can form between L2 and S3.
• E. AVXLAN tunnel can form between L1 and L4.

Answer: ABD

NEW QUESTION 8
Which two statements about the seamless EVPN-VXLAN stitching interconnect gateways are correct? (Choose two.)

• A. IBGP is recommended for VXLAN stitching overlays.
• B. Interconnect gateways will rewrite the route target, route distinguishe
• C. and ESI values for each stretched virtual network.
• D. All EVPN routes types are forwarded among interconnect gateways in a full-mesh manner.
• E. The interconnect gateway can reside on the super spine layer of a multi-POD data center.

Answer: CD

NEW QUESTION 9
When considering VRF routing-instances for network segmentation, which two statements are true? (Choose two.)

• A. A logical interface can participate in multiple VRFs.
• B. Multiple VRFs on a single device consolidate routing information to a single table.
• C. VRFs have independent routing tables.
• D. VRFs support overlapping subnets.

Answer: CD

NEW QUESTION 10
You are deploying a 3-stage Clos IP fabric in your data center. In this scenario, which statement is correct?

• A. Each server-facing interface on a leaf node is always three hops away from other server-facing interfaces.
• B. Each spine node must be physically connected to all other spine nodes.
• C. There is an eight-spine node limitation.
• D. No direct physical connections exist between leaf nodes.

Answer: A

NEW QUESTION 11
Application developers are complaining that east-west server traffic is not being load balanced in your new data center. What are three reasons for this behavior? (Choose three.)

• A. BGP multipath is not configured.
• B. Policies for load balancing have not been configured.
• C. MP-BGP is not exporting the correct prefix type.
• D. There is insufficient spine to leaf bandwidth.
• E. ESI active/active has not been configured.

Answer: ADE

NEW QUESTION 12
You are required to create an IP fabric for your new data center. In this scenario, which protocol would be used to support EVPN?

• A. IS-IS with correct TLVs enabled
• B. MP-BGP
• C. OSPF
• D. any protocol with the appropriate APIs

Answer: B

NEW QUESTION 13
You are asked to build a single export policy that can be applied to all devices to advertise only loopback IP addresses in the 172.16.0.0/24 subnet into your EBGP IP fabric. In this scenario, which two solutions would accomplish this task? (Choose two.)
A)

B)

C)

D)

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: B

NEW QUESTION 14
Exhibit.

You are troubleshooting a traditional Clos Layer 3 IP fabric in your data center. You are reviewing the BGP configuration for one of your spine devices.
Referring to the exhibit, which statement is correct?

• A. This spine device will not install multiple next hops for remote destinations in its routing table.
• B. This spine device will not install any routes for remote destinations in its routing table.
• C. This spine device has three neighboring leaf devices.
• D. This spine device has three neighboring spine devices.

Answer: C

NEW QUESTION 15
You are building an IP fabric underlay for your data center. You are asked to ensure that the two spine devices are in the same AS (65000) while the six leaf devices are in a different AS (65512).
In this scenario, which two statements are correct by default? (Choose two.)

• A. All BGP routes advertised by a leaf device will be accepted on the spine devices.
• B. A leaf device will accept all BGP routes received from the spine that were originated from another leaf device.
• C. All BGP routes advertised by a leaf device will be rejected on the spine devices.
• D. A leaf device will reject all BGP routes received from the spine that were originated from another leaf device.

Answer: AB

NEW QUESTION 16
......