★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 350-050 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/350-050-dumps.html


Everyone is absolve to opt for any official certifications checkups how they consider nearly all suitalbe privately, nevertheless they?¡¥d dont sign up prior to many people be aware of the objectives, your maket-oriented discipline as well as the property value your official certifications, instead of thoughtlessly stick to the tide. One of the most necessary level will be to opt for official certifications evaluation as outlined by you hold specialties in addition to developmental orientations. One example is, you would like system in addition to desire to become a system officer, you could opt for accreditation involving Microsof company MCP, MCSE, in addition to Novells CNE, MCNE, along with Suns SCJP, etc; When you are used to data bank, you could use the checkups involving official certifications connected with data bank, including Microsof company MCDBA or even Oracle, Sybase, Sun microsystems. Apart from, in addition there are many authentications around the physique in addition to impression, persons, that are keen on graphic design, web site creating for example, can consider him or her.

2021 Jan bowa 350-050:

Q111. When troubleshooting wireless clients through the Client Sessions report on the Cisco WCS, which statement is correct? 

A. You are able to see the client password in case of PAP authentication. 

B. You are able to see the client username in case of a web authentication-enabled WLAN. 

C. You are able run a ping test for a single client at a time. 

D. You are able run a ping test for multiple clients at a time. 

E. You are able to reboot a client PC remotely. 

Answer: B


Q112. Which of the below statements is true about Radio Resource Management Neighbor messages? (Choose three.) 

A. they are transmitted at minimum power 

B. they are transmitted at maximum power 

C. they are transmitted at the highest data rate 

D. they are transmitted at the lowest supported data rate 

E. they are transmitted on all serviced channels 

F. they are transmitted every 60 seconds 

Answer: BDF


Q113. Which statement about heat maps on Cisco WCS is true? 

A. They are predictive and rely only on the accuracy of the information that is provided with the map. 

B. They are based on real-time actual values if Cisco Compatible Extensions is enabled on the APs. 

C. They are predictive but can be converted to real values by using the Refresh from network button. 

D. They are based on real-time actual values because of fingerprinting. 

Answer: A


Q114. Which two EAP methods are supported on H-REAP AP using a local RADIUS server? (Choose two.) 

A. PEAP 

B. EAP-FAST 

C. LEAP 

D. EAP-TLS 

Answer: BC


Q115. A network administrator changed some wireless network SSID configuration settings on an autonomous AP. As a result, old clients can still connect by using the saved configuration on their wireless networks; however, new clients are not able to view or connect to the SSID. 

What is most likely the cause of the problem? 

A. The network administrator configured the SSID to not accept any new clients. 

B. The network administrator removed the broadcast command from the SSID configuration. 

C. The network administrator removed the guest-mode command from the SSID configuration. 

D. The network administrator changed the encryption algorithm of the SSID. 

Answer: C


Refresh bt-350-ivory-050-gg:

Q116. Asset tags are not being detected correctly and re-verification of the correct configuration should be performed. It is also recommended that verification of correct asset tag RSSI detection and message forwarding is conducted. Which statement is correct about the RFID tag timeout settings, as you would see in a show advanced location summary on a Cisco WLC? 

A. The RFID tag timeout should be set to two to five times the longest tag transmission interval found in the tag population, including stationary and any in-motion tag transmission intervals. 

B. The RFID tag timeout should be set to four to six times the longest tag transmission interval found in the tag population, including stationary and any in-motion tag transmission intervals. 

C. The RFID tag timeout should be set to three to eight times the longest tag transmission interval found in the tag population, including stationary and any in-motion tag transmission intervals. 

D. The RFID Tag RSSI expiry timeout cannot be configured; it is a fixed value (1200 seconds). 

Answer: C


Q117. Which local DHCP pools that are configured on an autonomous IOS AP will properly work and lease IP addresses to the wireless clients without using the "ip helper-address" command? 

A. only the pool configured for the native VLAN 

B. only the pool configured for the VLAN assigned to the SSID where the wireless clients are connected 

C. all of the configured local DHCP pools 

D. all of the configured local DHCP pools, if static routing is configured appropriately 

Answer: A


Q118. Refer to the exhibit. 

A network administrator is configuring and installing an indoor mesh network using two CAPWAP APs. The APs were out of the box and have already been installed in their designated locations. The RAP is joined to the controller and configured appropriately, but the MAP is not visible on the WLC. In the output shown, which of these explanations is the most likely reason for the issue? 

A. The MAP should have been primed to the WLC before being deployed. The Bridge Group Name is not configured by default. The AP policy for the MAP is not configured. 

B. The MAP should have been primed to the WLC before being deployed. The Bridge Group Name uses the MAC address and is configured but does not match, which is the reason for the failure. 

C. The MAP does not have to be primed to the WLC before being deployed to the field because the WLC discovery process is different for MAPs than it is for RAPs. The Bridge Group Name does not have to match but the RAP has to have the MAP MAC address added to its database. 

D. The MAP should have been primed to the WLC before being deployed. The Bridge Group Name does not need to match. The MAP is running an LWAPP image that requires its MAC address to be configured in the RAP in order for a successful join. 

E. The MAP does not have to be primed to the WLC before being deployed. The Bridge Group Name needs to match. The AP policy is automatically populated by the MAP discovery process via CAPWAP, but is failing in this example. 

Answer: A


Q119. A network administrator is trying to convert a Cisco Aironet 1250 Series Lightweight Access Point back to autonomous mode using a TFTP server and AP mode button. DHCP Option 43 is configured, but the AP is not connected to the controller. Console and physical access to the AP has been established. The TFTP server is local to the PC and the directory has the original image of "c1250-k9w7-tar.124-10b.JDA3.tar," downloaded from Cisco.com. The PC is directly connected to the access point, but the conversion is failing. Which one of these statements is a possible reason for the failure? 

A. The 1250 Series AP is a lightweight-only AP and needs a WLC. 

B. The image filename is incorrect. 

C. The lightweight AP has to be joined to the WLC and then converted, using the config ap tftp-downgrade command. 

D. Telnet is not enabled on the AP or WLC. 

E. The network administrator needs to use the archive command directly on the AP for this procedure to complete. 

Answer: B


Q120. You are designing a new WLAN for an old warehouse. To make sure that the spectrum analysis is accurate, which two of these devices should you try to remove from the warehouse? (Choose two.) 

A. old 2.4-GHz cordless phones 

B. new DECT 6.0 series cordless phones 

C. 900-MHz PA radio system 

D. the neighbor Wi-Fi system that operates in both 2.4 GHz and 5.0 GHz 

E. old microwave ovens 

Answer: AE