★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 350-050 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/350-050-dumps.html


Tested of 350-050 exam engine materials and braindumps for Cisco certification for IT learners, Real Success Guaranteed with Updated 350-050 pdf dumps vce Materials. 100% PASS CCIE Wireless Beta Written Exam exam Today!

2021 Dec bt-350-ivory-050-gg:

Q191. You are tasked with creating a controller-based high-density RF design. Which three factors determine the cell size? (Choose three.) 

A. antenna type 

B. ClientLink support 

C. basic data rate 

D. TPC threshold setting 

E. AP placement 

F. free space path loss 

Answer: ACD


Q192. Which of the below devices can cause unintentional RF jamming attacks against an 802.11 wireless network? (Choose two.) 

A. Rogue Access Points 

B. Microwave Oven 

C. Radar 

D. 900 Mhz cordless phones 

Answer: BC


Q193. Which regulatory body develops standards for European information and communication technologies? 

A. European Union 

B. European Telecommunications Standards Institute 

C. European Radio and Telecommunications Terminal Equipment Directive 

D. International Organization for Standardization 

Answer: B


Q194. Your company is using wireless voice clients that have a unicast push-to-talk-function. DTIM is set to 10. Users report that the audio is choppy. Which action should you take to try to resolve this issue? 

A. Lower the DTIM to 2. 

B. Lower the DTIM to 1. 

C. Disable power saving on the wireless device. 

D. Enable power saving on the wireless device. 

E. Raise the DTIM to 15. 

Answer: C


Q195. Company XYZ needs to establish network connectivity to a newly acquired, adjacent building less than 1 kilometer (3280 feet) away. The project calls for implementing a wireless solution using autonomous access points in a point-to-point bridging solution using external antennas on interface dot11radio1. You need to secure the bridge link with strong EAP, DOT1x, and WPA methods, using a local RADIUS server. However, the link cannot be established and the following message is observed in the logs: "DOT1X_SHIM-3-SUPP_START_FAIL: Unable to start supplicant on Dot11Radio1." What is most likely the root cause? 

A. The non-root bridge is not configured for WPA key management. 

B. There is RF interference corrupting the 802.11b/g RF signal. 

C. The non-root bridge does not have the correct authentication credentials configured. 

D. The RADIUS service on the root bridge is not started or needs to be restarted. 

Answer: C


Avant-garde 350-050 pass4sure:

Q196. Refer to the exhibit. 

Two Cisco WLCs on a Cisco WiSM and in the same mobility group are both running 4.2.209.0 code. All the WLANs on both Cisco WLCs are configured for H-REAP local switching. Based on the configurations that are shown, which WLAN or WLANs will still be correctly mapped to a local VLAN if an H-REAP mode AP moves between the two controllers? 

A. WLANs 2, 3, 4, and 5 

B. All the WLANs 

C. WLAN 1 

D. WLANs 2 and 5 

E. WLANs 1, 2, 4, and 5 

F. WLAN 5 

Answer: D


Q197. Refer to the exhibit. 

Looking at the packet capture between the client and AP during a voice troubleshooting session, what can you learn? 

A. The 802.1p COS value is marked as 5, which typically is used for the voice traffic that is encoded in G711. 

B. IP precedence is marked as 5 for the voice traffic that is encoded in G711, with a corresponding 802.11e UP marking of 6. 

C. The WMM UP value is marked as 5, which typically is used for the voice traffic that is encoded in G711, and DSCP is marked as EF. 

D. IP precedence is marked as 5, with a corresponding 802.11e UP marking of 6 and a correct DSCP marking to EF; the voice traffic is encoded in G711. 

E. The 802.1p COS value is marked as 5, with a correct DSCP marking to EF, and the voice traffic is encoded in G711. 

F. WMM UP marking is marked as 5, which typically is used for video traffic; this voice traffic stream is encoded in G711, and DSCP is marked as EF. 

Answer: F


Q198. Refer to the exhibit. 

Which EAP type does the diagram illustrate? 

A. EAP-TLS 

B. EAP-MD5 

C. PEAP 

D. EAP-GTC 

E. EAP-FAST 

F. LEAP 

Answer: E


Q199. Refer to the exhibit. 

The customer intermittently sees these messages in the WLC message logs. Which two sentences describe what these messages indicate? (Choose two.) 

A. This is an authentication process failure between the supplicant and RADIUS server for the unicast key. 

B. There is one more retransmit attempt allowed by default. 

C. There are two more retransmit attempts allowed by default. 

D. This is an encryption process failure between the supplicant and the WLC for the unicast key. 

E. This is an encryption process failure between the supplicant and the WLC for the broadcast key. 

F. This is an authentication process failure between the supplicant and the WLC for the broadcast key. 

Answer: BE


Q200. Which debug command is best to use when you suspect that a client will not connect to an autonomous AP because of an incorrect WPA PSK? 

A. debug dot11 mgmt station 

B. debug dot11 aaa authenticator process 

C. debug dot11 station connection failure 

D. debug dot11 encryption 

Answer: C