★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 350-001 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/350-001-dumps.html
Cause all that matters here is passing the Cisco 350-001 exam. Cause all that you need is a high score of 350-001 CCIE Cisco Certified Internetworking Expert exam. The only one thing you need to do is downloading Exambible 350-001 exam study guides now. We will not let you down with our money-back guarantee.
2021 Aug ccie 350 001:
Q1. Your Cisco network currently runs OSPF and you have a need to policy-route some specific traffic, regardless of what the routing table shows. Which one of these options would enable you to policy-route the traffic?
A. source IP address and the protocol (such as SSL, HTTPS, SSH)
B. the packet Time to Live and the source IP address
C. type of service header and DSCP value
D. destination IP address
Answer: A
Q2. Which two statements are true about bandwidth guarantee? (Choose two)
A. When congestion isn't present, the bandwidth command doesn't allow exceeding the allocated rate.
B. When congestion is present, the bandwidth command allows exceeding the allocated rate
C. When congestion is present, the bandwidth command doesn't allow exceeding the allocated rate
D. When congestion isn't present, the bandwidth command allows exceeding the allocated rate
Answer: CD
Q3. Refer to exhibits 1 and 2. In exhibit 1, all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2, the network management team reported that there is no utilization on the WAN link B. To solve this problem, you decide to change the logical topology of your LAN, but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design, automatic redundancy, and load balancing. Which one of these actions would be the best choice?
A. Use MHSRP, with three users using router A as the default gateway and three users using router B as the default gateway.
B. Keep HSRP and activate PBR to redirect half of the traffic to the other WAN link.
C. Use the backup interface on the WAN link B to provide load balancing for all users.
D. Use GLBP instead, because it provides you with up to three MAC addresses for the same default gateway virtual IP address.
E. Use GLBP instead, because it provides you with up to four MAC addresses for the same default gateway virtual IP address.
Answer: E
Q4. Refer to the exhibit. In this network, R1 is configured not to perform autosummarization within EIGRP. What routes will R3 learn from R2 through EIGRP?
A. 172.30.1.0/24 and 10.1.2.0/24; EIGRP only performs autosummarization at the edqe between two major networks.
B. 172.30.0.0/16 and 10.1.2.0/24; R2 will perform autosummarization, although R1 will not.
C. Since R2 is configured without autosummarization, it will not propagate the 172.30.1.0/24 route.
D. 172.30.0.0/8 and 10.0.0.0/8
Answer: A
Q5. Which command will define a VRF with name 'CCIE' in IPv6?
A. ip vrf CCIE
B. ipv6 vrf CCIE
C. vrf definition CCIE
D. ipv6 vrf definition CCIE
Answer: C
Up to date pass4sure ccie r&s 350-001 v6.10:
Q6. Unicast Reverse Path Forwarding can perform all of these actions except which one?
A. examine all packets received to make sure that the source addresses and source interfaces appear in the routing table and match the interfaces where the packets were received
B. check to see if any packet received at a router interface arrives on the best return path
C. combine with a configured ACL
D. log its events, if you specify the logging options for the ACL entries used by the unicast rpf command
E. inspect IP packets encapsulated in tunnels, such as GRE
Answer: E
Q7. Which statement is true about shaping?
A. Shaping supports queuing of excess traffic.
B. Shaping can be applied both input and output on interfaces.
C. Shaping does not introduce delay in voice packet handling in the event of congestion.
D. Shaping makes instantaneous packet drop decisions.
Answer: A
Q8. Refer to the exhibit.
Router RTB is performing one-way redistribution from RIP to OSPF. Which outgoing interface will router RTD choose for packets to the 192.168.0.0/24 network, and why?
A. Fa0/1, because OSPF is a link-state routing protocol
B. Fa0/0, because RIP is a distance vector protocol
C. Fa0/0, because RIP has a higher administrative distance
D. Fa0/0, because OSPF has a lower administrative distance
E. Fa0/1, because OSPF has a lower administrative distance
F. Fa0/1, because RIP has a lower administrative distance
Answer: E
Q9. Refer to the exhibit. Assuming EIGRP is the routing protocol, if the link between R3 and R5 failed, how many queries would R5 send out?
A. R5 would not send out any queries, but it would switch to using the path trough R4.
B. R5 would send queries to R2 and R4.
C. R5 would send a query to R4, but not to R2.
D. R5 would send a query to R2, but not to R4.
Answer: A
Q10. Refer to the exhibit.
Which statement is correct?
A. Ethernet0/1 is in the outgoing interface list, and Ethernet1/0 is in the incoming interface list.
B. Ethernet1/0 is in the outgoing interface list, and Ethernet0/1 is in the incoming interface list.
C. This is not a valid MFIB entry.
D. This MFIB entry is currently not used to forward multicast traffic.
E. All multicast packets for this MFIB entry are punted.
Answer: B