★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-209 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/300-209-dumps.html
Master the 300-209 Implementing Cisco Secure Mobility Solutions (SIMOS) content and be ready for exam day success quickly with this Actualtests 300-209 exam guide. We guarantee it!We make it a reality and give you real 300-209 questions in our Cisco 300-209 braindumps.Latest 100% VALID Cisco 300-209 Exam Questions Dumps at below page. You can use our Cisco 300-209 braindumps and pass your exam.
Q101. Refer to the exhibit.
An administrator is adding IPv6 addressing to an already functioning tunnel. The administrator is unable to ping 2001:DB8:100::2 but can ping 209.165.200.226. Which configuration needs to be added or changed?
A. No configuration change is necessary. Everything is working correctly.
B. OSPFv3 needs to be configured on the interface.
C. NHRP needs to be configured to provide NBMA mapping.
D. Tunnel mode needs to be changed to GRE IPv4.
E. Tunnel mode needs to be changed to GRE IPv6.
Answer: E
Q102. Refer to the exhibit.
Which VPN solution does this configuration represent?
A. DMVPN
B. GETVPN
C. FlexVPN
D. site-to-site
Answer: B
Q103. Which two features are required when configuring a DMVPN network? (Choose two.)
A. Dynamic routing protocol
B. GRE tunnel interface
C. Next Hop Resolution Protocol
D. Dynamic crypto map
E. IPsec encryption
Answer: B,C
Q104. The following configuration steps have been completeD.
. WebVPN was enabled on the ASA outside interface.
. SSL VPN client software was loaded to the ASA.
. A DHCP scope was configured and applied to a WebVPN Tunnel Group.
What additional step is required if the client software fails to load when connecting to the ASA SSL page?
A. The SSL client must be loaded to the client by an ASA administrator
B. The SSL client must be downloaded to the client via FTP
C. The SSL VPN client must be enabled on the ASA after loading
D. The SSL client must be enabled on the client machine before loading
Answer: C
Q105. Which command enables the router to form EIGRP neighbor adjacencies with peers using a different subnet than the ingress interface?
A. ip unnumbered interface
B. eigrp router-id
C. passive-interface interface name
D. ip split-horizon eigrp as number
Answer: A
Q106. If the IKEv2 tunnel were to establish successfully, which encryption algorithm would be used to encrypt traffic?
A. DES
B. 3DES
C. AES
D. AES192
E. AES256
Answer: E
Explanation:
Both ASA’s are configured to support AES 256, so during the IPSec negotiation they will use the strongest algorithm that is supported by each peer.
Q107. Which technology does a multipoint GRE interface require to resolve endpoints?
A. ESP
B. dynamic routing
C. NHRP
D. CEF
E. IPSec
Answer: C
Q108. Scenario
Your organization has just implemented a Cisco AnyConnect SSL VPN solution. Using
Cisco ASDM, answer the questions regarding the implementation. Note: Not all screens or option selections are active for this exercise.
Topology
Default_Home
Which address pool is being assigned to the users connecting via the AnyConnect client?
A. AC_Address_Pool
B. Remote_Address_Pool
C. Outside_Address_Pool
D. VPN_Address_Pool
Answer: D
Explanation:
First Navigate to the Configuration -> Remote Access VPN tab and then choose the “AnyConnect Connection Profile as shown below:
Capture
Then, clicking on the AnyConnect Profile at the bottom will bring you to the edit page shown below:
Capture
From here we can see that the Client Address Pools in use is the “VPN_Access_Pool”
Q109. Which VPN feature allows remote access clients to print documents to local network printers?
A. Reverse Route Injection
B. split tunneling
C. loopback addressing
D. dynamic virtual tunnels
Answer: B
Q110. Which protocol supports high availability in a Cisco IOS SSL VPN environment?
A. HSRP
B. VRRP
C. GLBP
D. IRDP
Answer: A