★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-115 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/300-115-dumps.html


We are the very best within adding probably the most beneficial 300-115 equipment for our clients which will certainly make these people succeed in the real Cisco 300-115 examination. A perfect Cisco guide has a wonderful and greatest preparatory material which usually conditions a person fully and offers the confidence of the success which is not a little thing. Merely down load the actual Testking 300-115 Implementing Cisco IP Switched Networks free of charge demonstration features to find out the characteristics as well as level of Testking products. You will end up inspired in the 300-115 research guide pdf certainly. If you title a 100% victory, utilizing Testking 300-115 to your Implementing Cisco IP Switched Networks certified preparation is the best selection.

2021 Jul 9tut ccnp 300-115:

Q1. What is the function of NSF?

A. forward traffic simultaneously using both supervisors

B. forward traffic based on Cisco Express Forwarding

C. provide automatic failover to back up supervisor in VSS mode

D. provide nonstop forwarding in the event of failure of one of the member supervisors

Answer: D


Q2. Refer to the exhibit.


What is the result of the configuration?

A. The EtherChannels would not form because the load-balancing method must match on the devices.

B. The EtherChannels would form and function properly even though the load-balancing and EtherChannel modes do not match.

C. The EtherChannels would form, but network loops would occur because the load- balancing methods do not match.

D. The EtherChannels would form and both devices would use the dst-ip load-balancing method because Switch1 is configured with EtherChannel mode active.

Answer: B


Q3. A server with a statically assigned IP address is attached to a switch that is provisioned for DHCP snooping. For more protection against malicious attacks, the network team is considering enabling dynamic ARP inspection alongside DHCP snooping. Which solution ensures that the server maintains network reachability in the future?

A. Disable DHCP snooping information option.

B. Configure a static DHCP snooping binding entry on the switch.

C. Trust the interface that is connected to the server with the ip dhcp snooping trust command.

D. Verify the source MAC address of all untrusted interfaces with ip dhcp snooping verify mac-address command.

Answer: B


Q4. Refer to the exhibit.


Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?

A. switch1

channel-group 1 mode active switch2

channel-group 1 mode auto

B. switch1

channel-group 1 mode desirable switch2

channel-group 1 mode passive

C. switch1

channel-group 1 mode on switch2

channel-group 1 mode auto

D. switch1

channel-group 1 mode desirable switch2

channel-group 1 mode auto

Answer: D


Q5. After implementing VTP, the extended VLANs are not being propagated to other VTP switches. What should be configured for extended VLANs?

A. VTP does not support extended VLANs and should be manually added to all switches.

B. Enable VTP version 3, which supports extended VLAN propagation.

C. VTP authentication is required when using extended VLANs because of their ability to cause network instability.

D. Ensure that all switches run the same Cisco IOS version. Extended VLANs will not propagate to different IOS versions when extended VLANs are in use.

Answer: B


300-115 practice exam

Far out cbt nuggets ccnp switch 300-115 download:

Q6. Which statement describes what happens when a switch enters dual active recovery mode?

A. The switch shuts down and waits for the VSL link to be restored before sending traffic.

B. All interfaces are shut down in the formerly active virtual switch member, but the new active virtual switch forwards traffic on all links.

C. The switch continues to forward traffic out all links and enables spanning tree on VSL link and all other links to prevent loops.

D. The VSS detects which system was last in active state and shuts down the other switch.

Answer: B


Q7. Which statement describes what happens when a port configured with root guard receives a superior BPDU?

A. The port goes into errdisabled state and stops forwarding traffic.

B. The port goes into BPDU-inconsistent state and stops forwarding traffic.

C. The port goes into loop-inconsistent state and stops forwarding traffic.

D. The port goes into root-inconsistent state and stops forwarding traffic.

Answer: D


Q8. A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?

A. Configure the new load balancing method using port-channel load-balance.

B. Adjust the switch SDM back to "default".

C. Ensure that IP CEF is enabled globally to support all load balancing methods.

D. Upgrade the PFC to support the latest load balancing methods.

Answer: A


Q9. When two MST instances (MST 1 and MST 2) are created on a switch, what is the total number of spanning-tree instances running on the switch?

A. 1

B. 2

C. 3

D. 4

Answer: C


Q10. Refer to the exhibit.


A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be configured to mirror traffic to a packet sniffer that is connected to the distribution switch? (Choose three.)

A. A monitor session on the distribution switch with a physical interface as the source and the remote SPAN VLAN as the destination

B. A remote SPAN VLAN on the distribution and access layer switch

C. A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destination

D. A monitor session on the distribution switch with a remote SPAN VLAN as the source and physical interface as the destination

E. A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destination

F. A monitor session on the distribution switch with a physical interface as the source and a physical interface as the destination

Answer: BCD