★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 210-065 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/210-065-dumps.html
Youre never going to get any It all official certifications without having skill and working hard.The requirements from the expertise and capacities usually are numerous, the pursuing steps are similar.Do an individuals prefer to acquire Cisco examination? In the event that?¡¥s the situation, don?¡¥t fearfulness. Listed below are any steps to provide you with set to the special day. Initial, pick a official certifications. For these that are doubtful that official certifications to use, several ideas and ideas could be grasped over the web. Second step, guesstimate an individuals expertise. In this action, produce an introduction to an individuals expertise and then search for exploring things in which Cisco official certifications calls for. Some people found out that the ability factors are so ample they will only get lost in searching out the selling points. Think youre bored to tears by mastering courses without help? Why dont you pay a visit to a few It all official certifications boards to find out the alternative men do? Chances are youll control an individuals review schedule by doing this. The easiest method to reside fresh new should be to carry it official certifications exercising instructional classes.Process assessments may help you incomparable an individuals Cisco 210-065 assessment. Search online practice assessments that guide you actually analyse knowing about it and ability to the real assessment.Eventually, browse the vendor?¡¥s website. They generally present assessment guides and exercise questions zero cost to take. After youve completed the aforementioned several action, its possible youll reserve an individuals assessment at this point.
2021 Sep eugh c 210-065 civnd book:
Q11. A network administrator is asked to configure a video conference using the Cisco TelePresence MCU 5300. There is a requirement for participants to start with the same layout when joining the conference. How can this goal be accomplished?
A. Layouts cannot be customized on the MCU 5300.
B. Configure a custom layout for each user individually.
C. Configure a custom layout and apply the layout to all new participants.
D. Allow each endpoint to configure its own layout.
Answer: C
Q12. Cisco Video Surveillance Video Encoder cards perform which function?
A. the ability to use existing analog equipment with an IP-enabled video surveillance system
B. the ability to convert low-resolution video to high-definition video for video surveillance
C. the ability to stream digital media to digital media in an IP-enabled video recording environment
D. the ability to encrypt raw video signals to secure video signals
Answer: A
Q13. An engineer is configuring VIP mode for a Cisco TelePresence Multipoint Switch. What are three characteristics the engineer must keep in mind? (Choose three.)
A. VIP mode can be configured only when the meeting is not active.
B. The VIP is displayed on the center screen for three screen systems.
C. Network multipoint meetings are supported.
D. VIP mode timers must be configured from the CLI.
E. Locking is not supported.
F. Only one VIP can be configured for each meeting.
Answer: B,D,F
Q14. Management wants to modify Cisco TMS to allow users to configure the call behavior with their associated devices and dial from a single ID. Which feature needs to be enabled and configured?
A. Smart Scheduler
B. Low-touch Provisioning
C. FindMe
D. CMR Provisioning
Answer: C
Q15. Refer to the exhibit.
Under which tab can the registration status for the endpoint be found?
A. Diagnostics
B. Configuration
C. Call Control
D. Maintenance
Answer: A
Renewal causa c 210-065 civnd:
Q16. A Cisco TelePresence EX Series desktop endpoint failed to register to a Cisco VCS. The SIP status shows "Failed: 403 Forbidden" in the endpoint's web interface. What is the first thing that should be checked in the endpoint configuration settings?
A. Verify that the correct SIP authentication credentials have been configured.
B. Ensure that CallSetup Mode is set to Gatekeeper.
C. Verify that Outbound Connection Credentials are properly configured.
D. Check to see that SIP Mode is set to On.
Answer: A
Q17. Which CLI command can be used to reset the Cisco TelePresence System 500-32 personal video system to a factory condition?
A. utils factory reset 2
B. utils system factory init
C. xcommand defaultvalues set level: 2
D. xconfiguration default factory
E. utils reset factory
F. xcommand SystemUnit FactoryReset
Answer: B
Q18. How would an administrator reset a Cisco VCS Control appliance to the default configuration?
A. Via the CLI, log in as root and issue the factory-reset command.
B. Via the CLI, log in as root and issue the reset-defaults command.
C. Via the web GUI, log in as the administrator, choose Backup and Restore, and click the Factory Reset button.
D. Hold down the power button for 10 seconds until the light flashes.
E. Hold down the reset button on the back of the appliance for 10 seconds.
Answer: A
Q19. An end user using C series codec wants to change the participant layout for a meeting hosted on a Cisco TelePresence Server. What are three valid layout options available in codec web interface? (Choose three.)
A. single screen
B. loudest speaker
C. rolling
D. equal
E. custom
F. overlay
Answer: A,D,F
Q20. Which two methods can be used to set the default call protocol of a Cisco TelePresence endpoint running TelePresence codec firmware? (Choose two.)
A. Use the GUI and set System > H.323 > Settings > Default Call Protocol > H.323.
B. Use the CLI command xConfiguration Conference 1 DefaultCall Protocol: H323.
C. Use the CLI command Conference Default Protocol: H323.
D. Use the CLI command Default Protocol: H323.
E. Use the GUI and set Configuration > System Configuration > Conference > DefaultCall >
H.323.
Answer: B,E