★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-125 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/200-125-dumps.html


You will have instant access in order to our Cisco 200-125 exam products after confirming the particular payment at Examcollection. The actual Cisco 200-125 practice questions with verified answers are compiled along with revised by our subject matter specialists. Each of our experts possess make excellent contributions to our Cisco Cisco exam products. Weve got many consumers who have obtained the particular Cisco 200-125 certification. We are proud of the high passing ratio since all of us start.

2021 Oct 200-125 practice exam

Q121. - (Topic 4) 

Which command reveals the last method used to powercycle a router? 

A. show reload 

B. show boot 

C. show running-config 

D. show version 

Answer: D 


Q122. - (Topic 8) 

What are three reasons that an organization with multiple branch offices and roaming users might implement a Cisco VPN solution instead of point-to-point WAN links? (Choose three.) 

A. reduced cost 

B. better throughput 

C. broadband incompatibility 

D. increased security 

E. scalability 

F. reduced latency 

Answer: A,D,E 


Q123. - (Topic 3) 

Which command enables IPv6 forwarding on a Cisco router? 

A. ipv6 local 

B. ipv6 host 

C. ipv6 unicast-routing 

D. ipv6 neighbor 

Answer: C 


Q124. - (Topic 4) 

What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.) 

A. It requires the use of ARP. 

B. It can support multiple IPv6 subnets on a single link. 

C. It supports up to 2 instances of OSPFv3 over a common link. 

D. It routes over links rather than over networks. 

Answer: B,D 


Q125. - (Topic 8) 

Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms? 

A. HDLC 

B. PPP 

C. X.25 

D. Frame Relay 

Answer: B 


200-125 rapidshare

Renovate 200-125 exam answers:

Q126. - (Topic 9) 

Which step in the router boot process searches for an IOS image to load into the router? 

A. bootstrap 

B. POST 

C. mini-IOS 

D. ROMMON mode 

Answer: A 


Q127. - (Topic 9) 

Refer to the exhibit. 


What is the effect of the given configuration? 

A. It configures an inactive switch virtual interface. 

B. It configures an active management interface. 

C. It configures the native VLAN. 

D. It configures the default VLAN. 

Answer: A 


Q128. - (Topic 4) 

Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices? 

A. enable cdp 

B. cdp enable 

C. cdp run 

D. run cdp 

Answer: C 


Q129. - (Topic 5) 

Syslog was configured with a level 3 trap. Which 3 types of logs would be generated (choose four) 

A. Emergencies 

B. Alerts 

C. Critical 

D. Errors 

E. Warnings 

Answer: A,B,C,D 


Q130. - (Topic 4) 

Refer to the exhibit. 


What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.) 

A. Router(config)# interface fastethernet 0/0 

Router(config-if)# ip address 192.168.1.1 255.255.255.0 

Router(config-if)# no shut down 

B. Router(config)# interface fastethernet 0/0 

Router(config-if)# no shut down 

Router(config)# interface fastethernet 0/0.1 

Router(config-subif)# encapsulation dot1q 10 

Router(config-subif)# ip address 192.168.10.1 255.255.255.0 

Router(config)# interface fastethernet 0/0.2 

Router(config-subif)# encapsulation dot1q 20 

Router(config-subif)# ip address 192.168.20.1 255.255.255.0 

C. Router(config)# router eigrp 100 

Router(config-router)# network 192.168.10.0 

Router(config-router)# network 192.168.20.0 

D. Switch1(config)# vlan database 

Switch1(config-vlan)# vtp domain XYZ 

Switch1(config-vlan)# vtp server 

E. Switch1(config)# interface fastethernet 0/1 

Switch1(config-if)# switchport mode trunk 

F. Switch1(config)# interface vlan 1 

Switch1(config-if)# ip default-gateway 192.168.1.1 

Answer: B,E