★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 100-101 Exam Dumps (PDF & VCE):
Available on:
https://www.certleader.com/100-101-dumps.html
The particular examinees that study the Testking Cisco 100-101 dumps are usually achievement associated with highly qualified instructors, living a wonderful life. Testking may be dedicated to help make your future safe and start your Cisco 100-101 CCNA Interconnecting Cisco Networking Devices 1 (ICND1) test formulations by the newest up to date Testking tests 100-101 test engine. Your dreams should come correct by begin your 100-101 vce regarding CCNA Interconnecting Cisco Networking Devices 1 (ICND1) test via Testking Cisco examine guides just. You will not capable of stand out your abilities in the first endeavor associated with 100-101 test if you use any some other pathway compared to Cisco. Cisco Cisco 100-101 pdf will provide you with brilliance therefore making you adequate certain about your entire life.
2021 Jul ccent 100-101 book:
Q41. Refer to the exhibit.
What must be configured to establish a successful connection from Host A to switch SW-A through router RT-A?
A. VLAN 1 on RT-A
B. IP routing on SW-A
C. default gateway on SW-A
D. crossover cable connecting SW-A and RT-A
Answer: C
Q42. What must occur before a workstation can exchange HTTP packets with a web server?
A. A UDP connection must be established between the workstation and its default gateway.
B. A UDP connection must be established between the workstation and the web server.
C. A TCP connection must be established between the workstation and its default gateway.
D. A TCP connection must be established between the workstation and the web server.
E. An ICMP connection must be established between the workstation and its default gateway.
F. An ICMP connection must be established between the workstation and the web server.
Answer: D
Q43. If a host experiences intermittent issues that relate to congestion within a network while remaining connected, what could cause congestion on this LAN?
A. half-duplex operation
B. broadcast storms
C. network segmentation
D. multicasting
Answer: B
Q44. Which two options will help to solve the problem of a network that is suffering a broadcast storm? (Choose two.)
A. a bridge
B. a router
C. a hub
D. a Layer 3 switch
E. an access point
Answer: BD
Q45. Refer to the exhibit.
A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations.
A ping from Host1 to Host 2 fails, but the technician is able to ping the S0/0 interface of R2 from Host 1. The configurations of the hosts have been verified as correct. What could be the cause of the problem?
A. The serial cable on R1 needs to be replaced.
B. The interfaces on R2 are not configured properly
C. R1 has no route to the 192.168.1.128 network.
D. The IP addressing scheme has overlapping subnetworks.
E. The ip subnet-zero command must be configured on both routers.
Answer: C
Rebirth cisco ccna 100-101 pdf:
Q46. A network administrator is trying to add a new router into an established OSPF network. The networks attached to the new router do not appear in the routing tables of the other OSPF routers. Given the information in the partial configuration shown below, what configuration error is causing this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0
A. The process id is configured improperly.
B. The OSPF area is configured improperly.
C. The network wildcard mask is configured improperly.
D. The network number is configured improperly.
E. The AS is configured improperly.
F. The network subnet mask is configured improperly.
Answer: C
Q47. Which two of the following are true regarding the configuration of RouterA? (Choose two.)
A. At least 5 simultaneous remote connections are possible
B. Only telnet protocol connections to RouterA are supported
C. Remote connections to RouterA using telnet will succeed
D. Console line connections will nevertime out due to inactivity
E. Since DHCP is not used on Fa0/1 there is not a need to use the NAT protocol
Answer: AC
Q48. Refer to the exhibit.
An administrator replaced the 10/100 Mb NIC in a desktop PC with a 1 Gb NIC and now the PC will not connect to the network. The administrator began troubleshooting on the switch. Using the switch output shown, what is the cause of the problem?
A. Speed is set to 100Mb/s.
B. Input flow control is off.
C. Encapsulation is set to ARPA.
D. The port is administratively down.
E. The counters have never been cleared.
Answer: A
Q49. What are two recommended ways of protecting network device configuration files from outside network security threats? (Choose two.)
A. Allow unrestricted access to the console or VTY ports.
B. Use a firewall to restrict access from the outside to the network devices.
C. Always use Telnet to access the device command line because its data is automatically encrypted.
D. Use SSH or another encrypted and authenticated transport to access device configurations.
E. Prevent the loss of passwords by disabling password encryption.
Answer: B,D
Q50. What is the OSPF default frequency, in seconds, at which a Cisco router sends hello packets on a multi-access network?
A. 10
B. 40
C. 30
D. 20
Answer: A